Malcolm wrote:The bends sold at Tube Bending on cryers rd are usually rejects
whats rejects? as in defective?
Can anyone get exhaust pipe at a decent price, AKL?
Moderator: The Mod Squad
23 posts
• Page 2 of 2 • 1, 2
by 1I1 » Thu Jan 22, 2009 2:51 pm
kim0663 wrote:Malcolm wrote:The bends sold at Tube Bending on cryers rd are usually rejects
whats rejects? as in defective?
Meaning not good enough for sale - imperfections etc
Official TGP and TRD supplier to Toyspeed
TRD Clicky >>Here
mark@manawatu.toyota.co.nz (Please mention Toyspeed
)
TRD Clicky >>Here
mark@manawatu.toyota.co.nz (Please mention Toyspeed
)-
1I1 - Toyspeed Sponsor
- Posts: 3063
- Joined: Mon Oct 01, 2007 6:55 pm
- Location: Palmerston North
by Zestripper » Thu Jan 22, 2009 7:06 pm
There wasn't anything obviously wrong with the bends I bought. All uniform shape and length and no surface rust developing as if they'd been sitting around for any period of time. Might have seconds there as an even cheaper alternative?
I got my flanges and a flexi join from Autobend which isn't far from Tube bending. Autobend guy reckoned the price of the bends from TB was below their cost price. From my poor memory the 3inch 180 deg. mandrel bends from there were something like $80 each. Mild steel too.
I got my flanges and a flexi join from Autobend which isn't far from Tube bending. Autobend guy reckoned the price of the bends from TB was below their cost price. From my poor memory the 3inch 180 deg. mandrel bends from there were something like $80 each. Mild steel too.
- Zestripper
- Toyspeed Member
- Posts: 61
- Joined: Wed Jan 24, 2007 6:38 pm
- Location: Auckland
23 posts
• Page 2 of 2 • 1, 2
Return to General Car Discussion
Who is online
Users browsing this forum: No registered users and 20 guests