Got Hole?

General discussions on all non technical car related topics

Moderator: The Mod Squad

Got Hole?

Postby caldinagtt » Tue Nov 29, 2005 8:54 pm

your not going ot beleive but my enigine blew the other week put a rod out the side of the block creating a lovly litle hole thanks to rawmotorworx for the excellent tuning of the haltech ecu and the driving of my mechanic they managed to destry my engine. Wot im after is a short block for the gtt urgently as i would like my car back by xmas so i can get it ready for the nats if anyone can help out it would be greatly appreciated.
cheers
brian.
User avatar
caldinagtt
Toyspeed Member
 
Posts: 80
Joined: Mon Jul 26, 2004 8:35 pm
Location: auckland, maraitai

Postby snwtoy » Tue Nov 29, 2005 9:01 pm

User avatar
snwtoy
Toyspeed Member
 
Posts: 5810
Joined: Mon Aug 30, 2004 7:54 pm
Location: Auckland

Postby fivebob » Tue Nov 29, 2005 9:17 pm

Oh, I think they will believe it, some might have even predicted it :wink:

That block is what you need, but you should replace the oil pump, water pump, cam belt tensioners & pulleys and treat it to some new rings, if you want it to last long enough.

If it was me I would only use the block, crank & maybe the rods, and replace everything else, preferably with forged lower compression pistons. Actually that's not quite true, I'd only use the block and fit a stroker kit :twisted:
User avatar
fivebob
Toyspeed Member
 
Posts: 3879
Joined: Fri May 02, 2003 5:12 pm
Location: Tauranga

Postby XERO » Tue Nov 29, 2005 9:38 pm

Thats not good to hear... What sort of work were you getting done??

Good Luck gettin her back on the road...
Image
Altezza RS200 Z Edition
For performance parts :: www.drivenperformance.co.nz
User avatar
XERO
Toyspeed Member
 
Posts: 1080
Joined: Thu Jun 16, 2005 6:22 pm
Location: Auckland :: West

Postby Ako » Tue Nov 29, 2005 9:55 pm

Anthonym is selling a forged bottom end for sweet f-all on here, I was meant to grab it but disinformation put paid to that plan for me :cry:

Id grab it if I were you, its a hell bargain!
User avatar
Ako
Toyspeed Member
 
Posts: 776
Joined: Sun Aug 10, 2003 12:51 pm
Location: Elsewhere

Postby Adamal » Tue Nov 29, 2005 10:22 pm

Ako wrote:Anthonym is selling a forged bottom end for sweet f-all on here


Thats from an MR2 though....
Motorsport is like sex. You could take it to track and have a long, enjoyable session, or you could take it to the strip and get it over with in less than 20 seconds.
User avatar
Adamal
Toyspeed Member
 
Posts: 11592
Joined: Sun May 02, 2004 4:01 pm
Location: Waitakere Drift Stage (Ranges)

Postby anthonym » Wed Nov 30, 2005 8:18 am

Adamal wrote:
Ako wrote:Anthonym is selling a forged bottom end for sweet f-all on here


Thats from an MR2 though....


And only for sale to a good home :P.
User avatar
anthonym
Toyspeed Member
 
Posts: 709
Joined: Sat May 18, 2002 1:49 pm
Location: Auckland

Re: Got Hole?

Postby Inane » Wed Nov 30, 2005 11:48 am

caldinagtt wrote:your not going ot beleive but my enigine blew the other week put a rod out the side of the block creating a lovly litle hole thanks to rawmotorworx for the excellent tuning of the haltech ecu and the driving of my mechanic they managed to destry my engine. Wot im after is a short block for the gtt urgently as i would like my car back by xmas so i can get it ready for the nats if anyone can help out it would be greatly appreciated.
cheers
brian.


I hope the guys who did the work arent paying to fix it, from the sounds of it you brought this on yourself!
Last edited by Inane on Thu Dec 01, 2005 4:30 pm, edited 1 time in total.
User avatar
Inane
Toyspeed Member
 
Posts: 1374
Joined: Wed Dec 10, 2003 12:52 pm
Location: Wellington

Re: Got Hole?

Postby Akane » Wed Nov 30, 2005 2:54 pm

Inane wrote:


I hope the guys who did the work are paying to fix it.[/quote]

Watch, they'll say something along the lines of......... "TOO F*CKING BAD! GO CRY TO YOUR MOMMY IF YOU WANNA! WAHAHAHAHA" Or words to that effect.
No "stance", no "hellaflush", none of that bullshit. Nothing but no grip on full boost.
http://www.lol.co.nz/ random shit.
User avatar
Akane
Toyspeed Member
 
Posts: 4073
Joined: Tue May 14, 2002 2:08 am
Location: Auckland

Postby Inane » Wed Nov 30, 2005 3:32 pm

really?
hrmm... Id never get extensive work done somewhere which didnt warantee their work...
User avatar
Inane
Toyspeed Member
 
Posts: 1374
Joined: Wed Dec 10, 2003 12:52 pm
Location: Wellington

Postby Silent Knight » Wed Nov 30, 2005 3:35 pm

Inane wrote:really?
hrmm... Id never get extensive work done somewhere which didnt warantee their work...


Yea but if they waranty their work they're going to be giving a waranty on workmanship and parts supplied and installed.

They didn't supply the block/crank and they didn't install it therefore they won't cover any damage made to it.
Image
User avatar
Silent Knight
Toyspeed Member
 
Posts: 6188
Joined: Tue Aug 05, 2003 12:30 am
Location: 'Save the Whale Foundation'

Postby IH8TEC » Wed Nov 30, 2005 4:15 pm

that sux man, thats why i guess it's good to spend more and get a really reputable place to tune it?

sux about the extent of the damage though.
Current Rides: 1994 Hiace Custom
KTM 250sx

Previous Car: 1988 Toyota Levin 4agte
234kw atw and 12.5@183kmh
Sold to a muppit who wrecked it
Hmm
User avatar
IH8TEC
Toyspeed Member
 
Posts: 3128
Joined: Wed Nov 26, 2003 7:11 pm

Postby Drifter4ag » Wed Nov 30, 2005 4:18 pm

any engine can blow ..especially during tuning... for those that cry if a tuner blows up their engine you are in the wrong game.. you ask for massive power then specify how much safe power you want .. or build the engine for that task alone :) ...
engines are engines .. 3sgtes are prone to blowing up ..its a fact of life .. buy that built motor it will see you right.
Garage |-" '|
Current Rides
AE86 Notchy (Finally through compliance after 5 years)
Vitz RS :D

Previous,
1x SXE10 Altezza, 2xAE111 Caribs, 3xKP60, 2xke35 SR Coupes, 2xAE85s, 2xAE86 Road Car, 1xAE86 Drift Car 182kw@wheels, 1xJZZ30 Drift Car 360ps
Panspeed Special 450ps Drift Car
JZX91 MARK II CHASER
JZX81 MARK II CHASER..... so many more that i forgot....
Drifter4ag
Toyspeed Member
 
Posts: 1103
Joined: Tue May 14, 2002 11:55 am
Location: Auckland

Postby anthonym » Wed Nov 30, 2005 5:01 pm

Drifter4ag wrote:any engine can blow ..especially during tuning... for those that cry if a tuner blows up their engine you are in the wrong game..

What a crock :roll: engines blow because of stupidity on the part of the owner/tuner or both as in this case. Or because you are pushing the envelope of known safety limits (which are well established for the 3SGTE, so this would either be deliberate or stupid). Genuine unanticipated failure is so rare as to be inconsequential, it is almost always preventable.
3sgtes are prone to blowing up ..its a fact of life .. buy that built motor it will see you right.

BS again, see above, 3SGTEs are not prone to blowing up if treated appropriately.
User avatar
anthonym
Toyspeed Member
 
Posts: 709
Joined: Sat May 18, 2002 1:49 pm
Location: Auckland

Postby RedMist » Wed Nov 30, 2005 5:27 pm

Drifter4ag wrote:any engine can blow ..especially during tuning... for those that cry if a tuner blows up their engine you are in the wrong game.. you ask for massive power then specify how much safe power you want .. or build the engine for that task alone :) ....


I'm afraid that if my tuner managed to destroy my race 4age I would be most upset, and very suspicious. Something is either very wrong with the build or the tuning process. My engine is a grenade, pretty much on the edge of what can be achieved with a NA 4age build, however if I dont get a season from the engine without catistrophic failure then something is definately wrong. I do specify that my engine is slightly fat in order to facillitate this. However if I bought a Hasselgren and it didnt run on the ragged edge for at least a half season I would be very pissed.
The answer is Helmholtz!

Toyota ST185 Celica Rally.
Toyota ST205 Celica Rally.
Jimco/ Cosworth 350z Offroader - 609whp at 16psi
User avatar
RedMist
Old Skool User!
 
Posts: 3078
Joined: Tue May 21, 2002 12:39 pm
Location: Christchurch

Postby Ako » Wed Nov 30, 2005 5:38 pm

Bear in mind, some workshops actually have a disclaimer you sign before they touch it, saying "if something breaks when we're tuning it for power, you can't blame us" - within reason. Good luck getting any comeback unless you can PROVE beyond doubt it was their tuning which killed it, as opposed to the thing dieing on its own.
User avatar
Ako
Toyspeed Member
 
Posts: 776
Joined: Sun Aug 10, 2003 12:51 pm
Location: Elsewhere

Postby Loudtoy » Wed Nov 30, 2005 5:58 pm

Also the fact that when it blew it wasn't actually being tuned rather driven by the mechanic which, and although this really sucks, would probably have a sign somewhere saying all owners cars are stored and driven at the owners risk.
Kind ok like a doctor saying hey, i'm a doctor but all your surgery is at your own risk, so if i stuff up and leave a scalple (spelling) in you and later on it cuts you up from the inside out it's not my fault and i can't be blaimed.
However the tuner may not have had something like that and if you can prove it was a tuning issue which coul be picked up by checking parts of whats left you chould be able to get something from them.

Best of luck to you and if i hear of any short blocks going i'l put it up here for you to see.
TS Member sine 2001

Prado To tow stuff with
NZ Ae82 GT Liftback for gravel fun
Rodeo to do work stuff in
Big Ass Trailer to put stuff on
Car no 16 in a long line of less than ilustrious automobiles
User avatar
Loudtoy
Toyspeed Member
 
Posts: 1833
Joined: Tue Jun 04, 2002 9:26 pm
Location: In a ditch, watch for triangle!!

Postby suberimakuri » Wed Nov 30, 2005 6:22 pm

well as scuzzlebutt would say. 3s engines are a piece.
tuners/workshops are not always that flash.

I know Damian from A1 turbo's is a good tuner. And I'd trust Robin from Torque Performance too...
There are a lot of things that can go wrong at any time with cars..

But having someone tune my car is like letting some go for lap times around a circuit. Pushing something to the edge... I'd rather that be me.

and yes... i'm leaving a trail to the cliff.. with any 3s i can find.
User avatar
suberimakuri
Toyspeed Member
 
Posts: 1296
Joined: Tue May 14, 2002 12:58 am
Location: Auckland, NZ

Postby evil_si » Wed Nov 30, 2005 6:35 pm

so what did raw have to say for them selves?
User avatar
evil_si
Toyspeed Member
 
Posts: 2353
Joined: Sat Nov 01, 2003 6:19 pm
Location: TAURANGA, Pyes Pa

Postby atmosports » Wed Nov 30, 2005 7:55 pm

Unless you are using standard components ofr the use they are intended, I.e to rebuild a standard motor then there is no warantee's & no insurance cover. Hence the reason why most motorsport/performance workshops have big notices everywhere stating that tuning etc is at the owner's risk. I know I've checked with the majority of insurance companies with regards to public liability insurance & what would happen in the result of an engine going bang or car crashing due to components I have installed/tuned/manufactured & unless it's a standard replacement component being used for it's intended standard performance then if something does go wrong, I'm not liable as it's be used outside it's intended use/beyond specifications etc. Same reason why most aftermarket components have a big forr race use only or off highway use only printed on the box etc.

End of the day you car isn't standard, you knowingly took the risk of modifying it beyond standard. It went bang which is probably either poor workmanship or just bad luck so unfortunately your out of pocket. If your lucky then either your mechanic or Raw motorworx might come to the party & offer to help fix it(which they don't have to do lgeally only to save their reputation). I hear this sob story at least once a week but the moral of the story is go somewhere reputable that is recommended & if you have a modified car don't let anyone else drive it but you.
atmosports
Toyspeed Member
 
Posts: 569
Joined: Fri Jul 04, 2003 7:52 pm
Location: Auckland,New Zealand

Next

Return to General Car Discussion

Who is online

Users browsing this forum: No registered users and 7 guests

cron