Well we are at it again. This time we are coming to Christchurch. We will be running our EFI Tuning Stage 1 and Stage 2 training course on the 1st and 2nd of October.
Learn to Tune Like a Pro - EFI Tuning Stage 1
We will be covering the following topics.
- Basic engine operating principles
- Electronics and waveforms
- EFI components, inputs and outputs
- Fuel injector basics and deadtime/latency
- The speed density principle
- How to optimise your air fuel ratio
- How to optimise your ignition timing
- How to configure your ECU maps
- How to tune compensation maps
- The correct approach to tuning any engine
Learn to Tune like a PRO - EFI Tuning Stage 1 - School of Performance Education
Hands on Dyno Experience - EFI Tuning Stage 2
We will be covering the following topics.
- EFI Trouble shooting and diagnostics
- Using tuning equipment
- Configuring an ECU prior to tuning
- PID control basics
- Dyno operation and safety
- Using the dyno to control load and engine rpm
- Using the dyno to perform a ramp run
- Using the laptop to tune the engine
- Full tuning control
- Optimising the tune
For more information and registration please visit the link below:
Hands on Dyno Tuning Experience - EFI Tuning Stage 2 - School of Performance Education
Can we expect any Toyspeeders to attend?
STM School of Performance Education - Wellington EFI Tuning Stage 1 by STM101, on Flickr
STM School of Performance Education - Wellington EFI Tuning Stage 1 by STM101, on Flickr
STM School of Performance Education - Auckland EFI Tuning Stage 1 by STM101, on Flickr
