Input shaft bearing?
Moderator: The Mod Squad
3 posts
• Page 1 of 1
Input shaft bearing?
by 86 Power » Tue Aug 10, 2004 10:54 pm
Is it hard to change the input shaft bearing on a T50? Whats the procedure? I have a haynes manual. But the procedure is for a full strip down and rebuild.
-
86 Power - Toyspeed Member
- Posts: 384
- Joined: Fri Sep 20, 2002 2:41 pm
- Location: Auckland
by NZ_AE86 » Tue Aug 10, 2004 11:03 pm
Easy mate!
Take it apart as per manual, then remove counter gear from box, thenif you lift the main/tail shaft up you will be able to slide the input shaft off, press bearing off and then new one on. Reassemble in reverse order. When you pull then input shaft off be sure to catch all the internal rollers and put them back in when you reassemble it.
Take it apart as per manual, then remove counter gear from box, thenif you lift the main/tail shaft up you will be able to slide the input shaft off, press bearing off and then new one on. Reassemble in reverse order. When you pull then input shaft off be sure to catch all the internal rollers and put them back in when you reassemble it.
-
NZ_AE86 - Toyspeed Member
- Posts: 972
- Joined: Thu Jun 03, 2004 6:02 pm
- Location: Wellington
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 70 guests