Rear mount conversion problems - urgent

[LOMOFO]

I have put a 4agze out of an ae101 levin into my corolla wagon (ae101) and have come into a problem with the gear box mount not mounting up to the corolla x member. I have been told to try and get the levin x member and see if it works.

So what I want to know is, Will this fix my problem and mount up fine? will the x member fit into the car and still have the lower arms bolt on? I am guessing that I will need to find a non-super strut x member??

trying to sort of the prob so i can fix it in time to race at nightspeeds

[Silent Knight]

If you get the other xmember it should bolt on fine. Otherwise it's not really that hard drilling holes and making it fit.

[LOMOFO]

I'll try to get an x member tomorrow and try it out, but its good to know someone elses opinion that it will fit on, do you know if it has to be non super strut?

[Silent Knight]

If the box is going on to a superstut car then i'm pretty sure you'll need an xmember out of a superstrut setup as it will be a bit different but i'm not 100% sure on the exact measurements. A non superstrut member might still work.

Just try both and find out for yerself

Shoudn't be 2 hard to track down some x-members for a 101 shurely.

[LOMOFO]

My wagon does not have super strut so hopefully it shouldnt be a problem. If it all goes to plan i can get the x member out of the original car the motor came out of, i'm just hoping the dismantlers still have it there
Thanks a lot

[Silent Knight]

well if they don't it should be piece of piss to track one down anyhow....pik a part son

[LOMOFO]

Hopefully! and hopefully can get it done by friday. I really didnt think that the levin and corolla x members would be different so much of the things are the same in the car. Are the levin 4age and 4agze ones the same?

[KinLoud]

I'm no expert on this but I remember reading that one of the gze box mounts is different. Are you using the the s/c gearbox? If you don't have it already grab the gearbox mounts of the s/c car as well as the x member - it might save you going back to the wreckers again.

Ken
Ham
021 408 863

[LOMOFO]

I am using the s/c gear box and have all the mounts, so hopefully all i will need to pick up is the x member, i cant think of anything else i will need. Cheers.

[evil_si]

cut and weld the crossmember, just move the mount to were u need it.