fuel lines
Moderator: The Mod Squad
2 posts
• Page 1 of 1
by MetalupYoAss » Thu Nov 25, 2004 10:04 pm
get steel tubing from part master and bend it yourself, no need for bending/flare tools.
-
MetalupYoAss - Toyspeed Member
- Posts: 804
- Joined: Thu May 16, 2002 9:57 am
- Location: Lake Pukaki (Under the trees)
by CozmoNz » Fri Nov 26, 2004 12:09 am
i was about to say, $&#$% flaring it, i hate flaring pipes... especially if you $&#$% it up coz your not excactly sure about what your doing 
Outta here on Dec 5th, 1630, WHOO HOO
Rayne For President!
Rayne For President!
-
CozmoNz - Toyspeed Member
- Posts: 5490
- Joined: Wed Aug 18, 2004 7:48 pm
- Location: Brisbane, Australia
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 57 guests