Toyspeed.org.nz Message Board

Toyota Club of New Zealand Message Board

Skip to content

Injectors

The place for all technical car discussions. If you haven't already, read our Disclaimer first!

Moderator: The Mod Squad

Post a reply

Injectors

Postby CAMB01 » Thu Jan 06, 2005 11:53 pm

What higher flowing injectors can be fitted to a Big port 4AGE that have the same ohm rating.
What would happen if the ohm rating wasn't the same?
1993 Mitsubishi EVO 1 Racecar
1998 Mitsubishi Mirage ZR Asti Mivec (Daily Whip)
1989 AE91 FX-ZS (Previous)
1994 AE101 Levin 20v (previous)
1992 EE90 Corolla Sedan (previous)
1986 AE82 FX-GT Corolla (previous)
1989 AE92 FX-GTZ Supercharged (previous)
1992 EE90 Corolla Hatchback (previous)

Custom Works Automotive
http://www.HCCC.org.nz
User avatar
CAMB01
Toyspeed Member
 
Posts: 1440
Joined: Fri Jan 17, 2003 11:33 pm
Location: Wellyz
Top

Postby Malcolm » Fri Jan 07, 2005 8:47 am

but if you do run resistors make sure you get ones that dissipate enough power, not just those little .5Watt ones from electronic stores.
User avatar
Malcolm
Toyspeed Member
 
Posts: 4631
Joined: Tue May 14, 2002 1:01 am
Location: Auckland
Top

.

Postby swamp » Tue Jan 11, 2005 7:18 pm

i unintentionally run high impedence injectors on my 4age and it gave it an odd power curve. had a flat spot between 4 & 5k but still run ok.
swamp
Toyspeed Member
 
Posts: 69
Joined: Sun Dec 08, 2002 2:31 pm
Top
Post a reply

Return to Tech Questions

Who is online

Users browsing this forum: No registered users and 89 guests

Powered by phpBB® Forum Software © phpBB Group
Time : 0.018s | 11 Queries | GZIP : On
cron