Hay before I go I was wondering If anybody here knows what AC1 and ACT refer to on the pinout for a blacktop ECU. I know they are both air con amplifiers but I need to know which one to hook up to AC request and AC on, on the link computer.
These are the only two wires that I don't what to do with. Also does anyone know where to get a cheap clutch switch from for launch control/flat shifting?
Blacktop link plus install
Moderator: The Mod Squad
22 posts
• Page 2 of 2 • 1, 2
by AE111_modifier » Tue Oct 18, 2005 2:42 pm
-
AE111_modifier - Toyspeed Member
- Posts: 26
- Joined: Sat Jun 26, 2004 6:23 pm
- Location: Dunedin
by matt dunn » Tue Oct 18, 2005 9:55 pm
I fitted a switch to my clutch for launch control.
My car had a pedal stop on the clutch and I removed it and fitted a switch similar to a brake light sw to it, the thread was there and everthing for it to screw it into. I actually used a bonnet sw as it provides quite a bit of travel and adjustment.
matt
My car had a pedal stop on the clutch and I removed it and fitted a switch similar to a brake light sw to it, the thread was there and everthing for it to screw it into. I actually used a bonnet sw as it provides quite a bit of travel and adjustment.
matt
- matt dunn
- Toyspeed Member
- Posts: 7109
- Joined: Fri Sep 12, 2003 1:01 am
- Location: Timaru
22 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users and 6 guests