i know there are a lot of these and everyone gets sent to the LTSA website but I've looked around there but can't find anything.
is it possible to get a cert for modified xmember mounts etc without the engine bolted in or running etc??
I've seen plenty of "rolling bodies" certified for blah blah engine. have these people set everything up, got certs then removed everything or what??
reason I'm asking is I've been failed for the engine not running properly, and the people who do my wofs said a certifier should not fail a vehicle based on the performance of the engine.
certification query
Moderator: The Mod Squad
3 posts
• Page 1 of 1
certification query
by l1ttle_d3vil » Wed Nov 23, 2005 7:21 pm
-
l1ttle_d3vil - Toyspeed Member
- Posts: 2639
- Joined: Sun Jun 27, 2004 10:22 pm
- Location: Bay of Plenty
by vhpacer » Wed Nov 23, 2005 7:27 pm
Wouldnt it be easier to get the motor running properly, than removing it? 
I doubt you could get a cert without a motor because thats the whole point of a cert-making sure its held in well. If you catch my drift..... 
I doubt you could get a cert without a motor because thats the whole point of a cert-making sure its held in well. If you catch my drift..... -
vhpacer - Toyspeed Member
- Posts: 434
- Joined: Tue Oct 04, 2005 11:26 am
- Location: Chch
by Fraud » Thu Nov 24, 2005 2:44 pm
The car has to pass a road test if it is being certified for road use. So of course it has to be running.
People who have it certed for x motor would have had that motor in it running for it to pass cert.
People who have it certed for x motor would have had that motor in it running for it to pass cert.
- Fraud
- Toyspeed Member
- Posts: 416
- Joined: Tue Apr 12, 2005 1:13 pm
- Location: West Auckland
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests