Toyspeed.org.nz Message Board

by **levinwreck** » Tue Dec 13, 2005 10:18 pm

is it possible?? reason im getting a blactop without a a computer or wiring loom but i have a some sidies i was going to chuck onto a blue top. Just wanna know if its been done/possible

by **Ae92typeX** » Tue Dec 13, 2005 11:55 pm

no reason why its not possible with the right setup, but would take a bit of tuning to make it worth it imo... would be cool though!

by **RedMist** » Wed Dec 14, 2005 7:29 am

Personally I dont think its worth it. Substancial work in creating a manifold only to see a powerloss at some point in the curve.
It will also cost probably two or three times as much as a set of Blacktop throttle bodies.
If you want cheap, get yourself a set of silvertop TB's and a die grinder.
If you want cheap that works well, get yourself a set of silvertop TB's... and a silvertop head. And while you are at it, replace the rods with silvertop rods, and you may as well retain the silvertop pistons.....mmmm silvertop?

by **TRD Man** » Wed Dec 14, 2005 9:40 am

Yes it has been done. TRD used to make a manifold for twin sidedraughts onto 20V.
In terms of simplicity I'd tend to agree with Redmist. Sell your carbs on trademe and use the money to buy the bits that are missing from your blacktop.

What are the sidies?

by **levinwreck** » Wed Dec 14, 2005 5:19 pm

yea i know it wont be as fast but im missing the wiring loom and computer which i cant seem to find one. anyone know where i can find one?? sidies = sidedrafts.

Website · by **Emperor** » Wed Dec 14, 2005 5:34 pm

There's a carb'd RB25DE, I say go for it, it'd be different, sure not as fast

by **CozmoNz** » Wed Dec 14, 2005 5:42 pm

theres an ae86 in this book here, 4age 16v twin sidies trumpets and whatever else, 286 / 304 duration cams, revs to 10,000, makes 210hp @ the wheels.

But i mean, yeh, wuteva works

by **Mr Revhead** » Wed Dec 14, 2005 5:43 pm

how hard have you looked? its not as though they are rare......

by **bad20v** » Thu Dec 15, 2005 10:19 am

levinwreck wrote:yea i know it wont be as fast but im missing the wiring loom and computer which i cant seem to find one. anyone know where i can find one?? sidies = sidedrafts.

Took me 10 seconds to find: :roll:

Blacktop ECU + Wiring loom (Click Me)

by **atmosports** » Thu Dec 15, 2005 6:28 pm

On a side not I've got some 20V twin side draft manifolds, still haven't had a chance to bolt them up to a head & check clearances etc but I'm guessing they are a TRD copy. Brand new if anyone wants one I'll sell them for what they owe me.

Toyspeed.org.nz Message Board

20V Blacktop - Side draughted CARBS???

20V Blacktop - Side draughted CARBS???

Who is online