Toyspeed.org.nz Message Board

by **matt dunn** » Sat Jan 21, 2006 10:41 pm

I am fitting an early link to a std 4agze engine at the moment.

It is an older model LEM V3 so it's not pc compatable.

I was wondering if anyone here has a program for the link V3 to make it run.
I know that each system needs a different tune but rather than spend hours getting it to the point where it's ready to go to the dyno I thought someone may help me with a shortcut.

If someone has and is willing to share,
let me know.

Matt

by **suckymotor** » Sun Jan 22, 2006 1:31 pm

get hold of the link people in chch and they are able to put a tune on it for you

by **passenger pete** » Mon Jan 23, 2006 5:27 pm

Feel free to use my map, its a bit rich but drives ok

by **narlystarly** » Mon Jan 23, 2006 5:41 pm

Ive got the version 5 disc, will that not help at all?

by **RedMist** » Mon Jan 23, 2006 8:16 pm

He's talking about the map, not the software.

Unfortunately all my maps are NA.

by **matt dunn** » Thu Jan 26, 2006 1:32 am

passenger pete wrote:Feel free to use my map, its a bit rich but drives ok

Cool thanks,
I might take you up on your offer.

Toyspeed.org.nz Message Board

link program for a std GZE?

link program for a std GZE?

Who is online