Hey guys i was just wondering if anyone has done or knows how much work is involved in getting a st185 3sgte into a mr2 gt.
What needs to be changed etc ?
thanks mike
st185 motor in mr2 gt
Moderator: The Mod Squad
4 posts
• Page 1 of 1
st185 motor in mr2 gt
by eritate » Wed May 24, 2006 4:36 pm
I am a timewaster. Ignore anything I say
-
eritate - Toyspeed Member
- Posts: 736
- Joined: Thu Feb 17, 2005 9:14 pm
- Location: Palmy North
by Rob » Wed May 24, 2006 6:50 pm
I've done the opposite
Needed to swap: drivers mounting point
thermostat housing
maybe water pump
crank pulley?
It pretty much goes straight in just odds and that you can bolt on really
Needed to swap: drivers mounting point
thermostat housing
maybe water pump
crank pulley?
It pretty much goes straight in just odds and that you can bolt on really
1990 ST185H - project
1996 VS Acclaim wagon
1996 VS Acclaim wagon
-
Rob - Toyspeed Member
- Posts: 633
- Joined: Wed Sep 04, 2002 2:29 pm
- Location: Gulf Harbour
by Dell'Orto » Wed May 24, 2006 7:04 pm
Use the search function, its been covered plenty.
1988 KE70 Wagon - Slowly rusting
1990 NA6 MX-5 - because reasons
2018 Ranger - Because workcar
1997 FD3S RX-7 Type R - all brap, all the time
OMG so shiny!
1990 NA6 MX-5 - because reasons
2018 Ranger - Because workcar
1997 FD3S RX-7 Type R - all brap, all the time
OMG so shiny!
Quint wrote:Not just cock, large cock.
-
Dell'Orto - ** Moderator **
- Posts: 17494
- Joined: Tue Jul 08, 2003 5:07 am
- Location: Straight out the ghetto, Lower Hutt
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 6 guests