hey just wiring the TPS on my 4agte redtop bigport and was wondering for hose that have done it can they remember the wire colours or pinouts for which wires to use. Just wanna make sure ive done it properly as i cant start the car yet (ignitor still not wired)
oh also if anyone is using a bf legacy with their link and they have a pin out of that, it would be much appreciated also.
-Speed
Link and TPS
Moderator: The Mod Squad
2 posts
• Page 1 of 1
by SpeedRacer » Wed Aug 09, 2006 7:24 pm
ok i think ive answered my own question, but to make sure
from top to bottom:
E2: ground
IDL: idle switch
VTA: Resistor (increased throttle opening = increased resistance)
Vcc: +12V
VTA is TPS wie on link
Vcc is 5V line
E2 Ground
IDL not needed
is this right?
from top to bottom:
E2: ground
IDL: idle switch
VTA: Resistor (increased throttle opening = increased resistance)
Vcc: +12V
VTA is TPS wie on link
Vcc is 5V line
E2 Ground
IDL not needed
is this right?
Sinister Sleeper 35
-
SpeedRacer - Toyspeed Member
- Posts: 407
- Joined: Tue Apr 12, 2005 10:30 am
- Location: Palmy
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 11 guests