Toyspeed.org.nz Message Board

by **bluemaumau** » Tue Apr 03, 2007 5:33 pm

are all 16v the same specs?

i have bluetop cams in a bigport gze.

if they arnt all teh same do i use the gze or bluetop clearance, cheers

by **AE82 FXGT** » Tue Apr 03, 2007 7:50 pm

Interesting Q, I need to know too!
Also what torque do they go down too?

by **Pelo** » Tue Apr 03, 2007 9:20 pm

Looking at the 3 different 4age manuals I have they are all the same spec.
Torque setting for the camshaft cap bolts is 130kg-cm / 9ft-lb / 13nm

by **bluemaumau** » Tue Apr 03, 2007 10:28 pm

Valve clearence (cold)

Intake 0.15 - 0.25mm / .006 - .010 inch
Exhaust 0.20 - 0.30mm / .008 - .012 inch

is that what you had pelo?

by **Pelo** » Wed Apr 04, 2007 12:24 am

Yeah that's correct

by **bluemaumau** » Wed Apr 04, 2007 12:24 am

cheers,

by **bluemaumau** » Wed Apr 04, 2007 11:41 pm

inlet .006 - .010 inch
exhaust .008 - .012 inch

most of my inlets shims were at .006, should i be getting smaller ones as thats right on the limit or will that be ok?

btw one of my inlets scored .002 :oops:

need to know asap as ill order em tomorrow

by **Pelo** » Thu Apr 05, 2007 12:31 am

Yeah man should be all good its within the limits.

by **bluemaumau** » Thu Apr 05, 2007 11:28 am

yea had a chat to the toyota mechs in kumeu, they said just to replace the ones that are over/under

Toyspeed.org.nz Message Board

16v valve clearance

16v valve clearance

Who is online