Toyspeed.org.nz Message Board

by **fangsport** » Wed Apr 11, 2007 8:12 pm

Mr Revhead wrote::lol: sadly no, even worse, rear suspension of a WRX

but thats off topic....

on topic.... whos knows sizes of 4k bellhousing bolts??

same as nearly every other Toyota i have worked on

by **Mr Revhead** » Wed Apr 11, 2007 8:14 pm

12x1.25..... lenght is more what im after

i have a 4k and a k50
but no bolts.....

Website · by **Bling** » Wed Apr 11, 2007 11:46 pm

if someone doesn't have one lying around, PM me and i'll whip one out the KP when its not raining

OMG so shiny! · by **Dell'Orto** » Thu Apr 12, 2007 12:00 am

Mr Revhead wrote:12x1.25..... lenght is more what im after i have a 4k and a k50
but no bolts.....

From my pile I have under the car, there appear to be 3 different lengths. There are long ones that go all the way through, some that bolt into the block, and the one random one at the bottom, which had a 10mm head. I'm unsure if they're the original bolts though, I'd not be at all surprised if they werent.

by **fangsport** » Thu Apr 12, 2007 12:33 am

Mr Revhead wrote:12x1.25..... lenght is more what im after i have a 4k and a k50
but no bolts.....

approx.75 and 50 threaded section, not including head. as well as a couple of 10x1.25 @50-ish mm for starter

by **Mr Revhead** » Thu Apr 12, 2007 9:47 am

awesome. cheers guys
at least gives e a starting point!!

nice quote fangsport

by **Chickenman** » Thu Apr 12, 2007 9:52 am

And 90 mm seems to be a good length for a 4age onto a supercheap engine stand... make sure you grab a few washers though.

(just in case someone searches for something similar)

Toyspeed.org.nz Message Board

Engine on engine stand?

Who is online