Stiffest possible shocks for z10,a61,ae86?????

[MrDori]

Need to find out what are the stiffest Gas shock insrts i can source for my z10, would like them to be as short as possible, like 50-61mm sorter than stock. i beleive ae92 size is about what i want but needa bell hella stiff.

[fangsport]

scope out something from a 3-5 tonne truck, cut the mount off the bottom and fit a spacer??

[deaf_rattle]

i can find the part number for what i ran if needed.

I had to run a spacer in the housingas it was about 2inches shorter than stock

[rwd_mayhem]

i can find the part number for what i ran if needed.

I had to run a spacer in the housingas it was about 2inches shorter than stock

where do you get the spacer from?

[deaf_rattle]

stocks supplied it with the shocks.
But you just need to buy some thick walled pipe (4mm wall) and then have it cut to the length you need

[MrDori]

yea done that, what rate springs did you run?

I wont need a spacer as ill chop the strut down to suit as to keep good amounts of travel

[big_boy]

have some old air ones if any one wants to by them i know with 3 motors in the back (5M`s) it droped about 3mm witch was quite impressive that was on 120psi when then let all the air out & sat it on the bump stops to get them out