Toyspeed.org.nz Message Board

Toyota Club of New Zealand Message Board

Skip to content

20v extractors on 16v,o2 sensor question

The place for all technical car discussions. If you haven't already, read our Disclaimer first!

Moderator: The Mod Squad

Post a reply

20v extractors on 16v,o2 sensor question

Postby fx gt » Sat Feb 02, 2008 7:36 pm

have put 20v extractors on my 16v 4age
how do i hook up the o2 sensor as the 20v dosnt support this on the extractors.

thanks
fx gt
Toyspeed Member
 
Posts: 1667
Joined: Wed Jan 12, 2005 6:43 pm
Top

Postby Lloyd » Sat Feb 02, 2008 8:05 pm

Buy a nut to fit the oxygen sensor thread, drill a hole in the exhaust further down, weld on the nut and screw the sensor in
User avatar
Lloyd
** Moderator **
 
Posts: 6195
Joined: Tue Oct 15, 2002 1:50 pm
Location: Dunedin
Top

Postby Adamal » Sun Feb 03, 2008 3:16 am

The 20v 2-1 section has the oxy sensor hole in it. You'll probably want to get this as well, as the flange on the 20v extractors doesn't meet up correctly with the 16v 2-1 section.
Motorsport is like sex. You could take it to track and have a long, enjoyable session, or you could take it to the strip and get it over with in less than 20 seconds.
User avatar
Adamal
Toyspeed Member
 
Posts: 11592
Joined: Sun May 02, 2004 4:01 pm
Location: Waitakere Drift Stage (Ranges)
Top

Postby fx gt » Mon Feb 04, 2008 4:08 pm

Adamal wrote:The 20v 2-1 section has the oxy sensor hole in it. You'll probably want to get this as well, as the flange on the 20v extractors doesn't meet up correctly with the 16v 2-1 section.


haha yeah aldery got the 20v 2-1 in there,thanks though
can i use one of the wires from the 20v oxy sensor or shall i just get a single wire 3gste one?
fx gt
Toyspeed Member
 
Posts: 1667
Joined: Wed Jan 12, 2005 6:43 pm
Top
Post a reply

Return to Tech Questions

Who is online

Users browsing this forum: No registered users and 8 guests

Powered by phpBB® Forum Software © phpBB Group
Time : 0.014s | 10 Queries | GZIP : On