Toyspeed.org.nz Message Board

by **the fallen303** » Fri Mar 21, 2008 7:29 pm

hey guys, just wondering where abouts to tee in the control line for the boost controller for a 2jzgte? fitting an HKS EVC4 into a 2jzgte aristo.

by **Crucible** » Sat Mar 22, 2008 11:47 am

the solenoid should just tap in between manifold vac and WG servo so it can bleed off.

is that what you meant??

by **the fallen303** » Sat Mar 22, 2008 4:25 pm

technically, yes, but the sequential setup on the 2jz is a lot more complex than that. if it was just that, it would have been running a long time ago, haha.

by **d1 mule** » Sat Mar 22, 2008 5:54 pm

the fallen303 wrote:technically, yes, but the sequential setup on the 2jz is a lot more complex than that. if it was just that, it would have been running a long time ago, haha.

then look at it as an excuse to go big single lol far less faffing around then

by **the fallen303** » Sat Mar 22, 2008 7:35 pm

for a daily, i like the power delivery of the twins. plus it's the missus car, i've got my supra for playing with. just doing BPU's with the aristo.

by **d1 mule** » Sun Mar 23, 2008 1:12 am

the fallen303 wrote:for a daily, i like the power delivery of the twins. plus it's the missus car, i've got my supra for playing with. just doing BPU's with the aristo.

small single then??? lol!!!! 2J for the misses.......MEAN!!!! :twisted:

Toyspeed.org.nz Message Board

2jzgte EBC install

2jzgte EBC install

Who is online