2C engine bellhousing
Moderator: The Mod Squad
4 posts
• Page 1 of 1
2C engine bellhousing
by Lloyd » Wed May 14, 2008 7:27 pm
Alright, want to clear this up for once. Do the 2C engine gearboxes bolt up to S series engines? And if so does the engine sit on the original angle or does it stand them up?
-
Lloyd - ** Moderator **
- Posts: 6195
- Joined: Tue Oct 15, 2002 1:50 pm
- Location: Dunedin
by strx7 » Wed May 14, 2008 7:51 pm
yes they are the SAME engine bolt pattern.
Need to mill 10mm apprx off the front face to get the input shaft to meet up with the pilot bearing.
Need to mill 10mm apprx off the front face to get the input shaft to meet up with the pilot bearing.
Online Car Forums - Where Hui seems to take preference over Do-ey
HDJ81- 112AWKW @ 10psi), FC3S (Tarmac Spec 335rwhp@11psi), 3SGTE stroker - replacement body found.
Motorsport Bay of Plenty - http://www.mbop.org.nz
HDJ81- 112AWKW @ 10psi), FC3S (Tarmac Spec 335rwhp@11psi), 3SGTE stroker - replacement body found.
Motorsport Bay of Plenty - http://www.mbop.org.nz
- strx7
- Toyspeed Member
- Posts: 3707
- Joined: Mon May 24, 2004 12:06 am
- Location: Tauranga
by KinLoud » Fri May 16, 2008 12:07 am
Yes - I am running a C bellhousing behind my 3sge in my carina.
Search for some past posts of mine in regards to how I solved the input shaft vs pilot bearing.
You don't "need" to shave 10mm of the bell but it probably makes it less fiddly for solving other related problems like clutch release...
Ken
Ham
021 408 863
Search for some past posts of mine in regards to how I solved the input shaft vs pilot bearing.
You don't "need" to shave 10mm of the bell but it probably makes it less fiddly for solving other related problems like clutch release...
Ken
Ham
021 408 863
I used to think that the orange and green tictacs gave you special powers. The orange ones would make you stronger and the green ones would make you faster. So i used to eat some green ones and run around my lounge as fast as i could, then eat the orange ones and try to pick up the sofa. I wish it were true!
-
KinLoud - ** Moderator **
- Posts: 2893
- Joined: Thu May 16, 2002 7:39 pm
- Location: Auckland
by .:O4AGTZ:. » Sun May 18, 2008 12:15 am
yea should bolt up no probs as long as you mill a bit off the front face
- .:O4AGTZ:.
- Toyspeed Member
- Posts: 754
- Joined: Sun Jun 11, 2006 6:15 pm
- Location: Wellington
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 8 guests