Toyspeed.org.nz Message Board

by **themaleman** » Sat May 31, 2008 4:01 pm

by **Crucible** » Sat May 31, 2008 9:44 pm

yup, BOV, map sensor and boost gauge all go to manifold vac.

manifold vac is basically any line AFTER the throttle plate.

by **themaleman** » Sat May 31, 2008 10:00 pm

as in the lines the left arow are pointing to are also 'vac lines'? the same as on the tb(right arrow)

by **themaleman** » Sun Jun 01, 2008 10:31 pm

....?

by **IH8TEC** » Sun Jun 01, 2008 10:41 pm

run your bov off a better vacuum source. drill and tap the manifold if you have to.

by **escortman** » Mon Jun 02, 2008 12:12 pm

yeh im going to drill and tap a new vacum feed for my bov when i pull motor out

by **themaleman** » Mon Jun 02, 2008 6:58 pm

as in the lines the left arow are pointing to are also 'vac lines'? the same as on the tb(right arrow)

can someone please clarify

by **escortman** » Mon Jun 02, 2008 7:23 pm

the 1s on left are but i think the one on right doesnt have vac, or somethign like that thats why i didnt use it, maybe diff tho

quick question