Toyspeed.org.nz Message Board

by **Nezza** » Mon Jan 12, 2009 7:46 pm

Hey

I have jus put a new engine into my starlet, i changed the distributor over as the old one was bung.

How do i get it firing off the irst cylinder for timing?

by **RS13** » Mon Jan 12, 2009 8:13 pm

Line up the mark on the crank pulley?

by **Rob** » Mon Jan 12, 2009 9:19 pm

If it is an ep starlet then the distributor will only go in one way, so just set it up same as the old one and you should be sweet

Toyspeed.org.nz Message Board

Engine Timing

Engine Timing

Who is online