Toyspeed.org.nz Message Board

by **Wolf_Tm250** » Tue Jan 20, 2009 10:57 pm

Hello,
I have to install 264 cams on a friend decatted st202:
any advice on which LCs use now during installation, before playing on the dyno?
Is it an engine that likes overlap?
Thanks.

by **Celica RA45** » Wed Jan 21, 2009 12:22 am

try 100btdc and 100 atdc abd see how that goes but what you could do is set it up like std and see how it runs most beams motors run 264 as std cam profile

by **Wolf_Tm250** » Wed Jan 21, 2009 3:08 am

Celica RA45 wrote:try 100btdc and 100 atdc abd see how that goes but what you could do is set it up like std and see how it runs most beams motors run 264 as std cam profile

Ok, thanks a lot !

Bye

Toyspeed.org.nz Message Board

3sge cam timing

3sge cam timing

Who is online