Ok so have searched around a bit both on here and google and can't find an answer anywhere so basicly
are the inner cv knuckles for an ae101 manual the same size as for an auto?? not to worried about axle sizes etc as i can sort that part out easily enough.
Just want to know if the inner part is the same where it fits into the outer part of the inner cv if that makes sense
Inner cv sizes
Moderator: The Mod Squad
4 posts
• Page 1 of 1
Inner cv sizes
by Loudtoy » Mon Jan 04, 2010 6:32 pm
TS Member sine 2001
Prado To tow stuff with
NZ Ae82 GT Liftback for gravel fun
Rodeo to do work stuff in
Big Ass Trailer to put stuff on
Car no 16 in a long line of less than ilustrious automobiles
Prado To tow stuff with
NZ Ae82 GT Liftback for gravel fun
Rodeo to do work stuff in
Big Ass Trailer to put stuff on
Car no 16 in a long line of less than ilustrious automobiles
-
Loudtoy - Toyspeed Member
- Posts: 1833
- Joined: Tue Jun 04, 2002 9:26 pm
- Location: In a ditch, watch for triangle!!
by soopachargen » Tue Jan 05, 2010 6:36 pm
just a bit of useless information... ae111 inner cv's are considerably smaller than ae101 inners
When in doubt, down and out.
"This is the Internet, it has no sympathy and shows no mercy. It feeds on weakness and preys on sensitivity. It will e-kill you at the first opportunity. Be brave or be e-dead." - NZHONDAS
"This is the Internet, it has no sympathy and shows no mercy. It feeds on weakness and preys on sensitivity. It will e-kill you at the first opportunity. Be brave or be e-dead." - NZHONDAS
-
soopachargen - Toyspeed Member
- Posts: 1598
- Joined: Thu Aug 05, 2004 1:54 pm
- Location: Silverdale
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests