Toyspeed.org.nz Message Board

by **eskimo** » Wed Mar 31, 2010 8:02 pm

Hey,

Simple question and at the risk of sounding dumb.

Im replacing the front engine mount(cheers Mark for the new one) on my AE111 this weekend so my question is, can i just whip the naffed one out without having to support the engine with a engine crane?

Cheers
Jordon

by **Burning Angel** » Wed Mar 31, 2010 8:11 pm

sure can, you may need a jack on the bottom of the engine to align the bolt for the new one tho.

The front and rear mount don't really support the engine in those, they just stop it rocking back and forth under accel/braking.

by **eskimo** » Wed Mar 31, 2010 8:16 pm

Cheers, thought that was the case but wasnt 100% sure. Where the best place to put the jack on the engine...off the gearbox close to the block?? obviously not the sump

by **Burning Angel** » Wed Mar 31, 2010 8:25 pm

yea you got it, definitely not on the sump. where you said will be fine

by **eskimo** » Wed Mar 31, 2010 8:30 pm

Sweet, cheers!

by **ChaosAD** » Thu Apr 01, 2010 7:14 am

Rear engine mount is an absolute bitch to get to.

Front one is a piece of piss, dont even need to jack up the car

by **eskimo** » Thu Apr 01, 2010 8:24 am

Yea luckly that one is sweet

Toyspeed.org.nz Message Board

AE111 front engine mount

AE111 front engine mount

Who is online