.
I've got a set of dobi lowering springs on the ga shocks (shown) and the factory springs on the jza billies (also shown). What would be the better spring to use?
Cheers.
aftermarket lowering springs vs JZA70 factory springs.
Moderator: The Mod Squad
4 posts
• Page 1 of 1
aftermarket lowering springs vs JZA70 factory springs.
by Quint » Sun May 09, 2010 6:44 pm
Swapping over the ga70 hubs for jza70 hubs. Here's a photo of the two side by side for size comparison for anyone interested.
.
I've got a set of dobi lowering springs on the ga shocks (shown) and the factory springs on the jza billies (also shown). What would be the better spring to use?
Cheers.
.
I've got a set of dobi lowering springs on the ga shocks (shown) and the factory springs on the jza billies (also shown). What would be the better spring to use?
Cheers.
-
Quint - Toyspeed Member
- Posts: 1251
- Joined: Tue May 24, 2005 2:24 pm
by deaf_rattle » Sun May 09, 2010 6:54 pm
just forget about it and get the 1uz sorted!
See the animal in his cage that you built. Are you sure what side you're on?
You are all c**ts, ill kill you all
supported by
Click for boobies
You are all c**ts, ill kill you all
supported by
Click for boobies
-
deaf_rattle - Old Skool User!
- Posts: 8039
- Joined: Fri May 17, 2002 1:32 pm
- Location: right where he belongs
by Looonie » Mon May 10, 2010 1:37 pm
The factory springs on the bilsteins would probably be the better spring rate, but the dobi's would lower the car.
If you want it low, dobi+bilstein. If you want it to handle but look like a 4WD, stock bilstiens
If you want it low, dobi+bilstein. If you want it to handle but look like a 4WD, stock bilstiens
Rumple dee pumple dee doo...
-
Looonie - Toyspeed Member
- Posts: 1882
- Joined: Fri May 17, 2002 12:10 pm
- Location: Whangarei, NZ
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: Bing [Bot] and 5 guests