Toyspeed.org.nz Message Board

Toyota Club of New Zealand Message Board

Skip to content

Brake Pad Shapes

The place for all technical car discussions. If you haven't already, read our Disclaimer first!

Moderator: The Mod Squad

Post a reply

Brake Pad Shapes

Postby 85AW20v » Mon Mar 14, 2011 10:43 pm

Anyone know of a site with the Toyota brake pad shapes on it? Trying to match the outer rear pad of the AW11 to a set of 2 from something else otherwise I will have to buy 4 sets to get the 4 I want. Standard AW inner and outer are different shapes. The outer will fit both sides of the AE101 caliper bracket and disk I'm using and give about 30% more pad area than the standard 101 pads.
See ya

Simon
85 MR2 20v
User avatar
85AW20v
Toyspeed Member
 
Posts: 1059
Joined: Fri May 24, 2002 6:18 pm
Location: Taupo, NZ
Top

Postby RomanV » Mon Mar 14, 2011 11:17 pm

No, but I'm fairly sure if you go to BNT or similar they'll have a book which does exactly that.
User avatar
RomanV
Toyspeed Member
 
Posts: 4915
Joined: Wed Aug 13, 2003 12:17 am
Location: West Auckland
Top

Postby thegreatestben » Mon Mar 14, 2011 11:59 pm

Yup either BNT or Repco will have a silverline/bendix/TRW catalogue. Good fun flicking through the equivalent of a yellow pages.
User avatar
thegreatestben
Toyspeed Member
 
Posts: 2083
Joined: Sat Aug 26, 2006 5:09 am
Location: Lower Hutt
Top

Postby DRFTIN » Tue Mar 15, 2011 9:00 am

bendix.co.nz
User avatar
DRFTIN
Toyspeed Member
 
Posts: 1106
Joined: Tue Nov 19, 2002 6:39 pm
Location: Chch
Top
Post a reply

Return to Tech Questions

Who is online

Users browsing this forum: No registered users and 60 guests

Powered by phpBB® Forum Software © phpBB Group
Time : 0.031s | 11 Queries | GZIP : On