what rwd car has the same floor pan (or close 2) an st183

[wde_bdy]

i personally don't see where the big issue is, if he has a few clues and some 'kiwi-cleverness' or No.8 wire technology, then there is no reason why it can't be done at a reasonable cost, just to say that it has been done.

Very, very true. But generally people who ask on a forum rather than pull out a tape measure are not the sort of people who will see this level of modification through.

Callum

[Low_Aa63]

And if money is nooooo object as you imply, why not the latest spec celica?

Good luck though, we all gotta have dreams.

where did i imply money was no object??

Cos this would cost truckloads!



Unless you are the fabrication welding master of the universe and have access to the best tools and the best workshop and aren't intending on doing it in the back shed with a small hammer, box of beers and a gas axe

And yet i still dont imply money is no object...yes i am the welding and fabrication master..... and i dont have a gas axe i have an ARC

[Low_Aa63]

i personally don't see where the big issue is, if he has a few clues and some 'kiwi-cleverness' or No.8 wire technology, then there is no reason why it can't be done at a reasonable cost, just to say that it has been done.

Very, very true. But generally people who ask on a forum rather than pull out a tape measure are not the sort of people who will see this level of modification through.

Callum

Ive allready done the measuring and ive come accross some interesting facts...hmmm... like its looking to be more feesable to use the st18x cabriolet.. you should see the chassis strenghtining (sp) going on in that car... does anyone know what they weigh?? i would say shat loads!!