Toyspeed.org.nz Message Board

Caldina GT-T · by **snwtoy** » Wed Jan 26, 2005 9:01 pm

Does anyone know how much it would cost to get mags re-drilled?
If so what type of shop can do it?
There seems to be bugger all available in the pcd and offset to suit the caldina....

Carina AA63 · by **kingcorolla** » Wed Jan 26, 2005 9:30 pm

youd be hard pressed to find somewere that will do it..

its illegal.

Caldina GT-T · by **snwtoy** » Wed Jan 26, 2005 9:38 pm

Damn.. even changing 5x114.3 to 5x100?

Well that just sux.

by **B_giB** » Wed Jan 26, 2005 10:40 pm

go to brugar engineering on barrys point road on the north shore, and ask for roddiz, they do lots of wheel stuff, if he can do it, you will need to take tyres off if they are on the rims, to take the tyres off come see me at my work and i will do it cheap as chips for ya :lol:

by **Dragger_Dan** » Thu Jan 27, 2005 12:10 am

I thought it was illegal too, but you do see loads of cars with drilled mags around the place. And some pretty shoddy jobs too. Anybody know the law on this?

Altezza RS200-Z · by **Sanxta** » Fri Jan 28, 2005 4:48 pm

prolly not legal unless cert'd - would be a huge safety hazard if not done properly

by **Dragger_Dan** » Fri Jan 28, 2005 4:59 pm

Sanxta wrote:prolly not legal unless cert'd - would be a huge safety hazard if not done properly

Most of the redrilling work I have seen on cars round the place is soooo bad. If you dropped the clutch fairly hard, you woudl have the studs turning inside the wheels pretty easily... yet I see so many cars round with them. WTF?

Toyspeed.org.nz Message Board

Re-drilling mags?

Re-drilling mags?

Who is online