Toyspeed.org.nz Message Board

Toyota Club of New Zealand Message Board

Skip to content

Blacktop intake

The place for all technical car discussions. If you haven't already, read our Disclaimer first!

Moderator: The Mod Squad

Post a reply

Blacktop intake

Postby redline racer » Wed Oct 05, 2005 11:08 pm

Hey, was wanting to know what the air sensor?-(plugs into the factory air box) on the black top does and can it be left out if adding a pod filter? some people seem to leave it out, others dont? any help appreciated.
redline racer
Toyspeed Member
 
Posts: 182
Joined: Sun Jan 04, 2004 7:59 pm
Location: Hastings
Top

Postby quinny » Wed Oct 05, 2005 11:38 pm

hiffing it never caused me beef :)
currently beating - AE101 Sedan, blacktop/6spd, tein coilovers, braided lines, cup holder, and every other bloody thing possible.
quinny
Toyspeed Member
 
Posts: 98
Joined: Thu Feb 05, 2004 5:49 pm
Location: Auckland
Top

Postby RedMist » Thu Oct 06, 2005 6:32 am

Sounds very much like IAT (Intake Air Temp). I would suspect that the ECU would detect a sensor failure and go into a limp home mode (over fuel, less power).

However as Link dont support IAT in the LEM I've never used one, so its pure supposition.
The answer is Helmholtz!

Toyota ST185 Celica Rally.
Toyota ST205 Celica Rally.
Jimco/ Cosworth 350z Offroader - 609whp at 16psi
User avatar
RedMist
Old Skool User!
 
Posts: 3078
Joined: Tue May 21, 2002 12:39 pm
Location: Christchurch
Top

Postby spencer » Thu Oct 06, 2005 3:08 pm

just leave it dangling around or zip tie it somewhere dont unplug it. Thats how mines setup on a 20v with open trumpets and a megasquirt
spencer
Toyspeed Member
 
Posts: 1328
Joined: Wed Oct 22, 2003 1:33 pm
Location: hamilton
Top
Post a reply

Return to Tech Questions

Who is online

Users browsing this forum: No registered users and 7 guests

Powered by phpBB® Forum Software © phpBB Group
Time : 0.017s | 10 Queries | GZIP : On
cron