Toyspeed.org.nz Message Board

by **dx_conversion_4age** » Wed Nov 30, 2005 8:40 pm

i know this sounds like a stupid quetion but i tryed taking my gearnob off today and failed. i throught it would just screw off?? well if anyone knows how to take them off it would be much appreciated. thanks

by **2LTR Rona** » Wed Nov 30, 2005 8:46 pm

Woudn't have thought that a KE70 is any different to any others. Could be that the thread inside the knob is worn and no longer working its way up the thread as it should.

Have you tried the good old twist and pull at the same time ?

Stupid question I know, but which way were you turning it ?

by **Ae92typeX** » Wed Nov 30, 2005 8:51 pm

as above, twist and pull

is it the standard one or an aftermarket? some aftermarket just allen key on rather than thread, hence turning wont welp at all.

by **2LTR Rona** » Wed Nov 30, 2005 8:58 pm

Ae92typeX wrote:is it the standard one or an aftermarket? some aftermarket just allen key on rather than thread, hence turning wont welp at all.

Good point on the aftermarket one :wink:

was a bit slow out of the blocks with that :lol:

Toyspeed.org.nz Message Board

ke70 gearstick??

ke70 gearstick??

Who is online