removing flywheel bolts (sorted)

[AE85.6]

im assuming these normally have loc tite or similar on them ? cause man they dont budge at all,

anyone got any tricks to getting them out?
if they have loc tite or something on them i assume i have to heat them up, but sadly i dont have a oxy torch handy so any other way to remove them ?

cheers

[Malcolm]

it shouldn't be too hard to do by hand, just lock up the crank pulley, and to free them give sudden impacts on your ratchet/breaker bar, rather than steady force.

[Lloyd]

Lever bar for locking it up and really long power bar (or short one and a decent bit of pipe ), or a rattle gun

[AE85.6]

god damn these are solid,
hmmm may have one of those small butane burners somewhere, might try that for heating them up.

[TRD001]

I used my foot and a long socket bar and gave it a good crack, should'nt be too hard, Use a bit of muscle lol

[Ako]

I farted round for an hour solid with a breaker bar, got the rattle gun on it and they were off in 1 minute.

[AE85.6]

nah im gonna bust a nut or something there must be loctite or something in there and i havent even got one, rattle gun hmmm could be an idea next now i just gotta find one to steal for a bit.

[AE85.6]

muahahah progress will now ressume,
one problem down
cheers all