hi,
anyone have any experience with this? I'm looking for some gear to hook the stock toyota ecu into my laptop for tuning and maybe an air/fuel meter too. anyone know if any of this is available in nz?
paul
ecu remapping
Moderator: The Mod Squad
5 posts
• Page 1 of 1
ecu remapping
by Paulio » Fri May 26, 2006 4:58 pm
-
Paulio - Toyspeed Member
- Posts: 818
- Joined: Sat Oct 09, 2004 6:57 pm
- Location: brotown, east coast
by atmosports » Fri May 26, 2006 6:45 pm
You can get the daughterboards & stuff to do it from Japan, Techtom & the likes do them, but last time I checked it looked expensive & complicated & an aftermarket ecu looked way easier & more than likely cheaper in the long run if you include the cost of tuning etc.
- atmosports
- Toyspeed Member
- Posts: 569
- Joined: Fri Jul 04, 2003 7:52 pm
- Location: Auckland,New Zealand
by Dell'Orto » Fri May 26, 2006 10:56 pm
To run a Toyota? You'd be better off going with a proper aftermarket ECU.
1988 KE70 Wagon - Slowly rusting
1990 NA6 MX-5 - because reasons
2018 Ranger - Because workcar
1997 FD3S RX-7 Type R - all brap, all the time
OMG so shiny!
1990 NA6 MX-5 - because reasons
2018 Ranger - Because workcar
1997 FD3S RX-7 Type R - all brap, all the time
OMG so shiny!
Quint wrote:Not just cock, large cock.
-
Dell'Orto - ** Moderator **
- Posts: 17494
- Joined: Tue Jul 08, 2003 5:07 am
- Location: Straight out the ghetto, Lower Hutt
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: Google [Bot] and 11 guests