Toyspeed.org.nz Message Board

by **Hbomb** » Tue May 30, 2006 12:48 pm

Any advice on a good place? Auckland region, pref central or North Shore. Thanks for helpin a newbie to the turbo seen.

by **Crucible** » Tue May 30, 2006 2:40 pm

Hbomb wrote:Any advice on a good place? Auckland region, pref central or North Shore. Thanks for helpin a newbie to the turbo seen.

Evil-Si does turbo conversions and intercooler plumbing etc he may be able to help you out!

by **Hbomb** » Tue May 30, 2006 3:56 pm

Thanks! Anymore suggestions...garages etc

by **GT4 20** » Tue May 30, 2006 4:09 pm

Let us know specifically what you want done. That way we can offer you better advice :wink:

Gary

by **Hbomb** » Tue May 30, 2006 7:33 pm

GT4 20 wrote:Let us know specifically what you want done. That way we can offer you better advice
Gary

Ok, basically a BOV installed for my other car which is a mitsi mirage vrx. Possibly sum other bits too. I have a gtapex trueno too so not too sure about turbo stuff

by **THA SHZ** » Tue May 30, 2006 8:13 pm

go to advanced automotive and ask for brad

by **GT4 20** » Tue May 30, 2006 8:24 pm

Hbomb wrote:
GT4 20 wrote:Let us know specifically what you want done. That way we can offer you better advice
Gary

Ok, basically a BOV installed for my other car which is a mitsi mirage vrx. Possibly sum other bits too. I have a gtapex trueno too so not too sure about turbo stuff

Guess that's pretty specific isn't it :roll:

Let me make it easy. Are they simple bolt on parts which most garages can do - or is fabrication required?
Gary

by **Hbomb** » Wed May 31, 2006 11:29 am

GT4 20 wrote:
Hbomb wrote:
GT4 20 wrote:Let us know specifically what you want done. That way we can offer you better advice
Gary

Ok, basically a BOV installed for my other car which is a mitsi mirage vrx. Possibly sum other bits too. I have a gtapex trueno too so not too sure about turbo stuff

Guess that's pretty specific isn't it

Let me make it easy. Are they simple bolt on parts which most garages can do - or is fabrication required?
Gary

Um prob just bolt on bits thanks Gary

by **Ako** » Wed May 31, 2006 1:59 pm

Mirage - Bov - Pull off the old BOV and put on the new one. Oh, and allow 30 seconds to blank up the old recirculation hole (you'll see it instantly).

Mitsi BOV inlets are rather conveniently the same size as most aftermarket ones. (or the other way round... meh.)

I just saved you $50 :lol:

by **no_8wire** » Wed May 31, 2006 11:58 pm

I was going to say...get it done it the backyard! :lol:

Toyspeed.org.nz Message Board

Good place to get BOV/performance parts installed?

Good place to get BOV/performance parts installed?

Re: Good place to get BOV/performance parts installed?

Who is online