Baffling/fabricating a drop tank
Moderator: The Mod Squad
3 posts
• Page 1 of 1
Baffling/fabricating a drop tank
by DIRTYDX » Thu Jul 12, 2007 2:34 pm
Hey all,im in the process of buiding a stainless steel drop tank for my Ke36,is there any drop tank masters out there...is there anything i should know prior to getting my fabricator to weld it up...baffles etc?Also sheet thickness 2mm?Any help will be greatly appreciated
- DIRTYDX
- Toyspeed Member
- Posts: 132
- Joined: Fri Apr 08, 2005 11:29 am
- Location: Whakatane/Tauranga
by strx7 » Thu Jul 12, 2007 3:32 pm
read the LTSA regs/rules about tanks, says what size sheet must be used etc. its on the LVVTA site
Online Car Forums - Where Hui seems to take preference over Do-ey
HDJ81- 112AWKW @ 10psi), FC3S (Tarmac Spec 335rwhp@11psi), 3SGTE stroker - replacement body found.
Motorsport Bay of Plenty - http://www.mbop.org.nz
HDJ81- 112AWKW @ 10psi), FC3S (Tarmac Spec 335rwhp@11psi), 3SGTE stroker - replacement body found.
Motorsport Bay of Plenty - http://www.mbop.org.nz
- strx7
- Toyspeed Member
- Posts: 3707
- Joined: Mon May 24, 2004 12:06 am
- Location: Tauranga
by DIRTYDX » Fri Jul 13, 2007 11:05 am
Had a look on that LVVTA site and i'l be damned if i could find it,i'l give our local certifier a ring today as for baffling the tank so that im not leaning out hitting hard corners with 1/4 of a tank of petrol does anyone have any tricks up their sleeves or know of a good site on this topic
- DIRTYDX
- Toyspeed Member
- Posts: 132
- Joined: Fri Apr 08, 2005 11:29 am
- Location: Whakatane/Tauranga
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 13 guests