Toyspeed.org.nz Message Board

Toyota Club of New Zealand Message Board

Skip to content

Intake placement

The place for all technical car discussions. If you haven't already, read our Disclaimer first!

Moderator: The Mod Squad

Post a reply

Intake placement

Postby Tumacki » Sat Jul 21, 2007 4:33 pm

Hey, im looking at a pod for my ae111 bzr. a few ideas were to put it in the bottom half of the air box so it gets the cold air through the existing pipes. the other was to move the battery sideways and put it there. All suggestions are with a heat sheild. Dont really want to the battery. some photos and suggestions would be excellent thanks.[/list]
Power is how fast you hit the wall... Torque is how far you take the wall with you.
User avatar
Tumacki
Toyspeed Member
 
Posts: 31
Joined: Mon Apr 02, 2007 11:26 am
Location: Palmerston North
Top

Postby ChaosAD » Sat Jul 21, 2007 4:41 pm

perhaps you could use a panel filter and ripout the resonators etc and run a duct from the front of the car to the airbox
User avatar
ChaosAD
Toyspeed Member
 
Posts: 2212
Joined: Wed Sep 03, 2003 11:40 am
Location: Whangarei
Top

Postby Tumacki » Sun Jul 22, 2007 11:10 pm

yeah it has the duct, factory behind the head light that goes to the air box. So just stick to the panel ya reckon?
Power is how fast you hit the wall... Torque is how far you take the wall with you.
User avatar
Tumacki
Toyspeed Member
 
Posts: 31
Joined: Mon Apr 02, 2007 11:26 am
Location: Palmerston North
Top
Post a reply

Return to Tech Questions

Who is online

Users browsing this forum: Google [Bot] and 8 guests

Powered by phpBB® Forum Software © phpBB Group
Time : 0.029s | 12 Queries | GZIP : On