what bore clearence used for the .050 over ? There are conflicting reports of whether the units are forged or cast. What have you guys had success with ?
Stock head gasket ok for that common overbore size ?
gze rebuild advice ?
Moderator: The Mod Squad
4 posts
• Page 1 of 1
gze rebuild advice ?
by dash » Tue Jan 08, 2008 11:44 am
- dash
- Toyspeed Member
- Posts: 44
- Joined: Thu Jan 19, 2006 6:22 am
by Mr Revhead » Tue Jan 08, 2008 1:32 pm
-
Mr Revhead - SECURITY!
- Posts: 24635
- Joined: Tue Jan 20, 2004 4:06 pm
- Location: Nelson
by IH8TEC » Tue Jan 08, 2008 4:01 pm
oh ffs, not this discussion again. rebuild it to the factory clearances.
Current Rides: 1994 Hiace Custom
KTM 250sx
Previous Car: 1988 Toyota Levin 4agte
234kw atw and 12.5@183kmh
Sold to a muppit who wrecked it
Hmm
KTM 250sx
Previous Car: 1988 Toyota Levin 4agte
234kw atw and 12.5@183kmh
Sold to a muppit who wrecked it
Hmm
-
IH8TEC - Toyspeed Member
- Posts: 3128
- Joined: Wed Nov 26, 2003 7:11 pm
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 16 guests