Toyspeed.org.nz Message Board

witch is the cooler motor?

For what?? 1UZ makes a better coffee table than the 1JZ

mr phreak is correct, the jz would simply fall over.

pyro_sniper2002 wrote:mr phreak is correct, the jz would simply fall over.

From laughing?

They'd both still be at a bit of a lean depending on the location of the sump.

Maybe if you do a high performance twin sump conversion where they're the same size at each end you'd be able to balance it perfectly. No more coffee spils.

so the uz would be better as a coffee table, and i guess it would be a better boat anchor too

I'd rather cast iron over alloy for an anchor, but thats just me.

Ummm... depends on the size of the lounge it is place in. If the area is quite big and square shaped, the 1UZ would be my choice but if it is to be placed in a more narrower area, say between two couches, I would say the 1JZ would fit better.

Don't ya think?

Personally I think that a 2JZ would be alot better opinion with the twin air-conditioning blowers hooked up to the side, providing warmth in winter.

If the room was big enough you could always use a 1gz-fe, make a nice stand for it and you would have the hella coffee table.