Toyspeed.org.nz Message Board

by **jeremy** » Mon Dec 05, 2005 12:29 pm

hey i did a quick search with out any luck
will a set of 20v black top pistons and rods fit my 16v redtop big port?
i think the journal sizes are the same but im not sure about the pistons
do they have 5 indents for the valves?
thanks for your time
jeremy

by **ATAl** » Mon Dec 05, 2005 5:54 pm

They will fit into the block no problem, but may have issues with the valves, i'm not sure.

by **RedMist** » Mon Dec 05, 2005 5:57 pm

The will fit. However you dont want either. The blacktop rods are weak. The blacktop pistons have three cutouts for the inlet valves that wont match up to the two inlet valves on your engine. It wont interfer with valve action, however wont promote a clean flame propogation. IE lower HP.

by **crispy'86** » Mon Dec 05, 2005 6:36 pm

what about 20v silvertop rods??

by **Mr Revhead** » Mon Dec 05, 2005 6:43 pm

yes they will be fine
id go silvertop rods and a TRD 0.5mm headgasket.
actualy id try and find a smallport

by **crispy'86** » Mon Dec 05, 2005 6:44 pm

that's what i was thinking along the lines 20v rods

by **jeremy** » Mon Dec 05, 2005 6:55 pm

ok then ill scrap that idea!!
does anyone have a set of 20v silver top rods laying about collecting dust??
ive located a set of smallport 16v pistons
whats a trd head gasket worth?
thanks for your time guys!!
jeremy

by **crispy'86** » Mon Dec 05, 2005 7:07 pm

20v rods ask Matt Dunn, TRD head gasket retail for $150-175 depending where you get it from.

by **Mr Revhead** » Mon Dec 05, 2005 7:09 pm

my arse they do

by **jeremy** » Mon Dec 05, 2005 7:21 pm

what can you do them for? i could probably get one through work but ive booked up enough to my poor boss!!
thanks

by **crispy'86** » Mon Dec 05, 2005 7:22 pm

Of ourse that was without the TS discount of 10% :wink:

by **AceSniper** » Mon Dec 05, 2005 8:19 pm

try $100 area for TRD goodness

by **crispy'86** » Tue Dec 06, 2005 12:55 pm

AceSniper wrote:try $100 area for TRD goodness

They come down in price....,..NICE!!!!!!!!

by **Mr Revhead** » Tue Dec 06, 2005 1:00 pm

they havnt been that price for.... um ever

by **crispy'86** » Tue Dec 06, 2005 5:54 pm

Mr Revhead wrote:they havnt been that price for.... um ever

Thought that was too good to be true cause they go up and down as the exchange rate changes.

by **Mr Revhead** » Tue Dec 06, 2005 6:00 pm

no, i mean they have never been as exspensive as you said.

price doesnt change due to exchange rate

Toyspeed.org.nz Message Board

16v/20v 4age parts

16v/20v 4age parts

Who is online