Toyspeed.org.nz Message Board

Toyota Club of New Zealand Message Board

Skip to content

Whats the standard S/C engine pulley diameter???

The place for all technical car discussions. If you haven't already, read our Disclaimer first!

Moderator: The Mod Squad

Post a reply

Whats the standard S/C engine pulley diameter???

Postby ae82charged » Tue Jan 17, 2006 5:18 pm

as above
ae82charged
Toyspeed Member
 
Posts: 19
Joined: Tue Oct 11, 2005 8:04 am
Location: North shore, Auckland
Top

Postby Rick » Tue Jan 17, 2006 5:43 pm

Apparently the standard crank pulleys seem to vary from 146-152mm but the one I had on my motor was 150mm from a AE101 gtz
Image
Corolla Levin AE-85 1984(Project car)
Corolla Runx Z (Runabout)
User avatar
Rick
Toyspeed Member
 
Posts: 1712
Joined: Fri Feb 06, 2004 6:52 pm
Location: West Auckland
Top
Post a reply

Return to Tech Questions

Who is online

Users browsing this forum: No registered users and 14 guests

Powered by phpBB® Forum Software © phpBB Group
Time : 0.027s | 11 Queries | GZIP : On