Toyspeed.org.nz Message Board

by **Kender** » Fri Jul 28, 2006 7:58 pm

Hi

Does anyone happen to know what the rev limit is for a 2E engine?
I've just bought a 1989 EE90 Corolla with 2E engine, but the car doesn't have a rev counter. I do however, know that it has no trouble doing 100km in 2nd gear

kender

by **fuel** » Fri Jul 28, 2006 8:21 pm

Haha ouch. The rev limit for a 2E would be around the 6000rpm~6500rpm mark. It will probably valve bounce not far after that.

by **Jebus** » Fri Jul 28, 2006 8:24 pm

Redlines about 6500 from memory which is about 90kmph in second.

by **Lloyd** » Fri Jul 28, 2006 8:27 pm

My injected 2E would do 7000 before it redlined. 60 in 1st, 107 in second, 150 in 3rd and so on. Didn't go much past that though.

by **CozmoNz** » Fri Jul 28, 2006 8:27 pm

yeh whats valve bounce at?

100kph in second is how many rpm... lol

by **Jebus** » Fri Jul 28, 2006 8:39 pm

Ive seen a carby 2E rev to 8, off the tacho.

Carby ones are probaly doing about 7000 at 100 in second.

by **mycoolcar** » Fri Jul 28, 2006 9:04 pm

Jebus wrote:Ive seen a carby 2E rev to 8, off the tacho.

Same. Its quite nutty when it does.

by **Kender** » Fri Jul 28, 2006 9:23 pm

I'm in the middle of installing a tacho in the EE90 at the moment. Have to admit I'm interested to know how many revs my little car was pulling. I'm finding the carby engine interesting as I'm used to efi engines with fuel cutoffs and electronic committees vetoing my decisions. The engine revs freeley, and it quite often feels too early to change out of 2nd before 80km

by **Leon** » Sat Jul 29, 2006 12:19 pm

Just before a piston comes out the bonnet.

by **dotdog** » Sun Jul 30, 2006 10:15 am

My turbo 2E revlimits at 6800rpm

by **Chickenman** » Sun Jul 30, 2006 11:58 am

Jebus wrote:Ive seen a carby 2E rev to 8, off the tacho.

Carby ones are probaly doing about 7000 at 100 in second.

My Corona did that too, carby 3sf... great times.

by **86_rolla** » Sun Jul 30, 2006 2:49 pm

yeh my carby 2E did 7200rpm but things started shaking hahaha

by **Stu-** » Wed Aug 02, 2006 6:29 pm

My carby 1e goes to 8000rpm on the tacho (fitted the Si dash).
My old 2e efi used to go to 7000-7200 before the ecu stepped in.
My old 2et used to get to 6800.

by **EVL20V** » Wed Aug 02, 2006 10:55 pm

2 different aftermarket tachos connected to my 2e rolla, showed 8000rpm valve bounce on the dot im pretty sure

60 in first 120 in second :lol:

enjoy the mighty 2e

by **Kender** » Thu Aug 03, 2006 8:18 pm

According to the aftermarket tacho I've hooked up, 100km in 2nd is 7200rpm. Changed to early, I still had 800rpm to go :twisted:

I've found that I'm less willing to repeat this, now that I can see exactly how many revs the little 2e's pulling :lol:

Toyspeed.org.nz Message Board

2E rev limit?

2E rev limit?

Who is online