where to get driveshaft custom made?

[Soarer T]

anybody know a good place doing driveshaft custom made. just doing mk3 manual conversion atm.i have only got an auto one, so just want to find a place who could make a manual one out of auto one. any ideas would be appriciated.cheers.

[Dunny]

You could try circle track engineering as a starting point....parkhouse road

Haven't used them personally so couldn't comment on workmanship

[johntramp]

circle track is good. will cost about $120 including balancing if you supply the 2 shafts to be joined and was done within 24 hours.

[Soarer T]

the problem is: i only have one auto shaft. anyway, i will give them a call to see how it goes. cheers for the infor.

[4000GT]

How did this go in the end? I will need one soon and any opinions would be appreciated.

[Soarer T]

cicle track is pretty good. they cut the middle piece between the yoke and the bearing side, reweld a longer piece and balanced it. cost about 150 bucks. but you need to bring the measurement to them.good guy to deal with.