Am rebuilding 3T turbo, found that as rods and cams etc have been sitting a number of months, that they've developed surface rust. Am I able just to scuff it off with a bit of wet and dry, or is there a better way?
Also, does anyone know of an online 2T/3T engine manual? Am after diagrams, head stud/bottom end torque settings etc, as engine is literally in pieces.
Cheers.
3T turbo
Moderator: The Mod Squad
2 posts
• Page 1 of 1
3T turbo
by RS13 » Sat Jun 16, 2007 8:33 pm
Daily driver: Toyota RunX/Toyota Caldina
Ex: 2x AE101, 5x KP60, KP61, EP71, 3x KE70, KE72, AE70, AE82, 2x TE71, AE90, AE92, ST170, plus 11 Hondas, 12 Nissans, 6 Fords, 4 Mazdas, 3 Mitsis, an Isuzu and a Lada!
Ex: 2x AE101, 5x KP60, KP61, EP71, 3x KE70, KE72, AE70, AE82, 2x TE71, AE90, AE92, ST170, plus 11 Hondas, 12 Nissans, 6 Fords, 4 Mazdas, 3 Mitsis, an Isuzu and a Lada!
-
RS13 - Toyspeed Member
- Posts: 3580
- Joined: Tue Oct 07, 2003 9:07 pm
- Location: Christchurch
by fangsport » Sat Jun 16, 2007 11:03 pm
i have a pdf version of the manual
I've been a bad bad boy. I should read the rules and behave before I get spanked by an admin
f#@k you i won't do what ya tell me
http://www.facebook.com/pages/Fangwood/225658970893404
f#@k you i won't do what ya tell me
http://www.facebook.com/pages/Fangwood/225658970893404
- fangsport
- Toyspeed Member
- Posts: 4169
- Joined: Sun Nov 30, 2003 10:52 am
- Location: Timaru
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 6 guests