Altezza rims
Moderator: The Mod Squad
5 posts
• Page 1 of 1
Altezza rims
by blake22 » Sun Aug 19, 2007 12:09 am
hey. Would anyone be able to tell me the inside diameter of there centre hole in there 17" standard altezza alloys.
- blake22
- Toyspeed Member
- Posts: 10
- Joined: Wed Dec 27, 2006 7:56 pm
by strx7 » Sun Aug 19, 2007 12:35 pm
3 or 4 mm smaller than a 2wd hilux stub is.........
Online Car Forums - Where Hui seems to take preference over Do-ey
HDJ81- 112AWKW @ 10psi), FC3S (Tarmac Spec 335rwhp@11psi), 3SGTE stroker - replacement body found.
Motorsport Bay of Plenty - http://www.mbop.org.nz
HDJ81- 112AWKW @ 10psi), FC3S (Tarmac Spec 335rwhp@11psi), 3SGTE stroker - replacement body found.
Motorsport Bay of Plenty - http://www.mbop.org.nz
- strx7
- Toyspeed Member
- Posts: 3707
- Joined: Mon May 24, 2004 12:06 am
- Location: Tauranga
by strx7 » Sun Aug 19, 2007 9:07 pm
one of my workmates is wanting to put some on his hilux and the hilux axle centre is slightly too large. he's planning on getting a little bit machined out of them so they fit
Online Car Forums - Where Hui seems to take preference over Do-ey
HDJ81- 112AWKW @ 10psi), FC3S (Tarmac Spec 335rwhp@11psi), 3SGTE stroker - replacement body found.
Motorsport Bay of Plenty - http://www.mbop.org.nz
HDJ81- 112AWKW @ 10psi), FC3S (Tarmac Spec 335rwhp@11psi), 3SGTE stroker - replacement body found.
Motorsport Bay of Plenty - http://www.mbop.org.nz
- strx7
- Toyspeed Member
- Posts: 3707
- Joined: Mon May 24, 2004 12:06 am
- Location: Tauranga
5 posts
• Page 1 of 1
Return to General Car Discussion
Who is online
Users browsing this forum: No registered users and 36 guests