spacers for hub - rotor hole

[IH8TEC]

hey, i'm wondering if you can buy these as my new rotors have a bigger center hold of 68mm, rather than the ae92 54mm, and i need the spacer to hold the rotor center so the load is not on the wheel studs.

does anyone know of someone that has them in stock, or even if you can buy them?

needed urgently, would rather not get them machined up if possible, as thats more time and money.

cheers
brendon

[fangsport]

2"ID tube with a 7mm wall, cut into small rings.

my best answer for the minute.

[neo]

A] You will need to get them machined .. (Do I hear sacrificial old rotors?)

B] You will need them for a cert

[IH8TEC]

yeah thats why i need to get them done,

guess i'll just have to make some.

calling to book cert tomorrow for couple of weeks time

[Trls250s]

I drew up a couple of these for old mans GT4, same problem except his discs needed to be spaced out 5mm as well. You need to locating ring to be bigger yea?