mitsi GDI

General discussions on all non technical car related topics

Moderator: The Mod Squad

mitsi GDI

Postby Stott69 » Sun Jan 18, 2009 11:56 am

hey bit off topic for toyspeed but the misses is getting a 97 misti RVR with the 1.8 GDI engine and tiptronic. So what is GDI and how well do these things go?
Image jzs147 Aristo money pit
User avatar
Stott69
Toyspeed Member
 
Posts: 2605
Joined: Thu Oct 04, 2007 11:51 am
Location: Wainui Central!

Postby Alex B » Sun Jan 18, 2009 11:59 am

GDI is direct injection. If I recall HRT's ranting correctly, they are to be avoided like the plague.
User avatar
Alex B
Toyspeed Member
 
Posts: 6539
Joined: Thu Nov 25, 2004 1:39 am
Location: London

Postby YeMs » Sun Jan 18, 2009 12:18 pm

make sure u always run it on 98 or it will carbon up like a bi*tch. give it a sweet engine flush aswell and put good quality oil in it.
Your local Hybrid Elite tech

Project - 93 jzx90 - 3uz ITBs, currently buying lotto tickets to fund manual conversion.
YeMs
Toyspeed Member
 
Posts: 1531
Joined: Tue Apr 29, 2003 4:03 pm
Location: Tauranga

Postby Lloyd » Sun Jan 18, 2009 12:34 pm

Gasoline Direct Injection. They carbon up running NZ fuel (a lot, not all), they're gutless, they don't save you any petrol etc etc.

And they're a Mitsi
User avatar
Lloyd
** Moderator **
 
Posts: 6195
Joined: Tue Oct 15, 2002 1:50 pm
Location: Dunedin

Postby Dell'Orto » Sun Jan 18, 2009 12:45 pm

Stay waaaaaaaaaaay waaaaaaaaay waaaaaaaaaay away. I've seen so many of these things so coked up you cant turn the cams 8O
1988 KE70 Wagon - Slowly rusting
1990 NA6 MX-5 - because reasons
2018 Ranger - Because workcar
1997 FD3S RX-7 Type R - all brap, all the time
OMG so shiny!

Quint wrote:Not just cock, large cock.
User avatar
Dell'Orto
** Moderator **
 
Posts: 17494
Joined: Tue Jul 08, 2003 5:07 am
Location: Straight out the ghetto, Lower Hutt

Postby Brick » Sun Jan 18, 2009 12:48 pm

Seen many throttle bodies being fixed due to carbon build up for running the cheaper fuel (cant be much worse than the guy i saw putting 91 in his st205 gt4 :lol: )

mate has the 2.4l legnum, slightly different but the car goes well and is a bloody nice car inside and out
User avatar
Brick
I know Kung Fu
 
Posts: 2695
Joined: Thu Feb 24, 2005 7:41 pm
Location: ChCh

Postby rollaholic » Sun Jan 18, 2009 12:52 pm

avoid tiptronic ones like the plague also

honestly just dont buy it

you will regret it
BASU!
User avatar
rollaholic
Toyspeed Member
 
Posts: 5383
Joined: Fri May 28, 2004 2:19 am
Location: West is Best

Postby Stott69 » Sun Jan 18, 2009 12:56 pm

would love her to buy a nice car but she is very difficult. the 2l turbo version runs the evo motor and drive train am i correct? are they the same?
Image jzs147 Aristo money pit
User avatar
Stott69
Toyspeed Member
 
Posts: 2605
Joined: Thu Oct 04, 2007 11:51 am
Location: Wainui Central!

Postby flygt4 » Sun Jan 18, 2009 1:06 pm

Stott69 wrote:would love her to buy a nice car but she is very difficult. the 2l turbo version runs the evo motor and drive train am i correct? are they the same?


not exactly the same, slight differences , smaller turbo, less power etc. gearbox and diffs have mildly different ratios too. the turbo ones are actually a really nice car. talk the mrs into getting one of them :lol:
User avatar
flygt4
Toyspeed Member
 
Posts: 3820
Joined: Sat Sep 20, 2003 6:57 pm
Location: Wellington

Postby Stott69 » Sun Jan 18, 2009 1:14 pm

give it 2 years then we'll both be 25 and il convert it.
Image jzs147 Aristo money pit
User avatar
Stott69
Toyspeed Member
 
Posts: 2605
Joined: Thu Oct 04, 2007 11:51 am
Location: Wainui Central!

Postby Mr Revhead » Sun Jan 18, 2009 1:36 pm

oh god no there not an RVR
she WILL regret it


note all the guys in the trade say no to mitsis.....
Being the subject of E-whinges since 2004 8)

http://www.centralmotorsport.org.nz/home

Image
User avatar
Mr Revhead
SECURITY!
 
Posts: 24635
Joined: Tue Jan 20, 2004 4:06 pm
Location: Nelson

Postby FXGTV » Sun Jan 18, 2009 3:20 pm

Mr Revhead wrote:oh god no there not an RVR
she WILL regret it


note all the guys in the trade say no to mitsis.....


I used to think that untill i bought a 2002 glxi misti wagon. Its got the 1.8 ltr n/a gs engine, and it drives really well. I use it as a trade vehicle and its been great. It even took a hit at 80 kms in the arse from a new Camry and came off better than the much heavier Camry :) (a pregnant woman crashed into me on Wednesday :( )
1988 r31 TI Skyline.
1982 ra60 Celica (my Aussie Toyota and axle stand warrior).
ex: 1991 Corolla, 1989 fxgt-v, 1985 aw11. 1992 sw20 gt-s. 2002 glxi Lancer wagon (work hack)
next car - another a-dub please!
User avatar
FXGTV
Toyspeed Member
 
Posts: 1703
Joined: Tue Sep 06, 2005 7:57 pm
Location: Brisbane

Postby rollaholic » Sun Jan 18, 2009 3:26 pm

mitsi make some okay cars, but they make at least as many not so okay ones too.anything with GDI badges or tiptronic transmissions are defintely on the shit list.

if she must have an RVR get a proper auto, or a manual. and get a 2 litre one, the 4G63 is not a bad unit ;)
BASU!
User avatar
rollaholic
Toyspeed Member
 
Posts: 5383
Joined: Fri May 28, 2004 2:19 am
Location: West is Best

Postby Mr. Mainstream » Mon Jan 19, 2009 11:02 am

Stott69 wrote: but she is very difficult.
Kick her
Current:77 MK2 Ford Escort L 1.3L
75 MK2 Ford Escort L 2.1L

Had: 2X Early Subaru Leggys GT Wags, 1X Subaru RS, 1X 2004 Subaru B4, 2x BFMP Turbo Sedan Famil's, 2x BFMR Turbo Sedan Famil's, AE92 FX-GT, 97 Holden Calais 3.8L
Supercharged 12psi ,Escort, BZ-R
Various Others
RomanV wrote: Mr Mainstream: The king of the Pushrods?!
User avatar
Mr. Mainstream
Toyspeed Member
 
Posts: 864
Joined: Thu Jan 01, 2004 7:44 pm
Location: Skoping for my Mazda in ChCh

Postby fuel » Mon Jan 19, 2009 12:23 pm

Only the early GDI motors have the problem with the manifolds caking up with carbon. Due to the lean burn direct injection, they run a high amount of EGR than normal motors to aid with lower emissions - the early GDI engines (from introduction in 96 until about 98/99ish) had alloy manifolds with a rough surface inside which the carbon from the EGR stuck to. The later model ones have a bakelite manifold which is smooth and don't have the same issues.

Bear in mind they are quite an advanced type of engine, and perhaps they were produced with not enough research and development gone into them. The system works great in ideal conditions such as with Japan's high quality and mostly high octane fuel, and the system has been licenced by many other manufacturors such as Renault and even Toyota (think D4-D petrol motors).

They *can* be run on lower octane fuel, the ECU is more than capable of running it to suit the lower octane, but there will be a reduction in power and economy for sure.

They got a really bad reputation right from the start here in NZ as when the masses of used jap imports flooded in, no one had experience with them here before as they weren't sold NZ-new (with the exception of a GDI pajero, but they're not common), and mechanics were all baffled on how to repair them.

If you do get one, make sure it has a good service history and get it thoroughly checked out by an experienced Mitsubishi mechanic who knows what they're looking for. They're not a bad car but they definitely wont stand up the abuse and neglect that Toyotas can handle.
LOUD NOISES!!!
User avatar
fuel
Toyspeed Member
 
Posts: 1532
Joined: Sun Jan 25, 2004 1:59 pm
Location: Brisbane Australia

Postby Stott69 » Mon Jan 19, 2009 1:01 pm

Cheers fuel, sheds more light on it. By manafold im gessing your talking exhaust, so upgrade to later model exhaust may reduce the problem? As for gear box, as long as is better than here current gaylant which is auto and has now started to pop out of drive, or not go in drive from any thing other than park, but only now and again.

By the way people the galants for sale, '95 auto, PM me for a look. Will put more info in the for sale thread soon
Image jzs147 Aristo money pit
User avatar
Stott69
Toyspeed Member
 
Posts: 2605
Joined: Thu Oct 04, 2007 11:51 am
Location: Wainui Central!

Postby Voyeur » Mon Jan 19, 2009 1:30 pm

We bought a Galant VRG bout 6 months back. only thing we noticed was noisy lifters. When i pulled the cam cover (big job) we found half an inch of sludge covering everything (everything) I ended up stripping the motor down and cleaning the whole lot. i got 4 litres of sludge out of the engine. Now its mint, round town its a pig on gas, about 420km to 65L on the open road its amazing, we did Palmy north to Hamilton 404km on 32L of gas.
My suggestion if you are not mechanically minded, and do lots of round town driving stay away from them.
Oh and we ripped out half of the EGR system while we were cleaning the engine, as well as polishing the inlet runners and a few other bits & pieces.
2005 vz ss commodore
Voyeur
Toyspeed Member
 
Posts: 194
Joined: Wed Feb 21, 2007 2:12 pm
Location: Feilding

Postby fuel » Mon Jan 19, 2009 1:30 pm

nah I mean inlet manifold. It's quite a weird setup, the inlet manifold mounts to the top of the cylinder head where the spark plugs are.

Here's a bit more info - http://autospeed.com/cms/A_2977/article.html

and a pic of it:

Image
LOUD NOISES!!!
User avatar
fuel
Toyspeed Member
 
Posts: 1532
Joined: Sun Jan 25, 2004 1:59 pm
Location: Brisbane Australia

Postby mr30%jr » Mon Jan 19, 2009 1:52 pm

the 1.8 is a guttless sack of shit. they have the misti cam tick they also have some weird EGR which gunks up with crap.

did i mention there gutless. if you REALLY have to get on e get a v6 6a13 not a 4G93

mum had a legnum guess why its gone.

cam covers leak. and the stupid plenum is in the middle so you have to take it all off.
st165, ae86 ,aw11 SC, aw11 blacktop, aw11 4afe, fzr250Exup, ta63 carina, b5 s4
User avatar
mr30%jr
Toyspeed Member
 
Posts: 1323
Joined: Sun Nov 21, 2004 11:51 pm
Location: Napier

Postby fuel » Mon Jan 19, 2009 2:10 pm

the 1.8 is gutless because it's in a heavy Legnum usually - drive a Lancer or Carisma with the same 1.8 GDI and it's a completely different experience. It's a practical economy car, not a performance car.

Most Mitsubishis have the hydraulic lifter 'tick', but so do alot of other manufacturors like Mazda, Nissan etc. It is usually masked by using a bottle of Promo MBL8 every oil change, or bite the bullet and replace the lifters for about $240 for the set.

I completely forgot that all other manufacturors are completely exempt from getting leaking rocker covers - god forbid that the rubber ages and leaks over time. Yes it's a hassle taking the inlet manifold off but it's no worse than doing the same on a V6 Camry for example.
LOUD NOISES!!!
User avatar
fuel
Toyspeed Member
 
Posts: 1532
Joined: Sun Jan 25, 2004 1:59 pm
Location: Brisbane Australia

Next

Return to General Car Discussion

Who is online

Users browsing this forum: Bing [Bot] and 31 guests