hydrolic clutch and ke35 peddle box?

[79rolla]

as a follow up from last thread in the end i took the whole peddle box out

and as i was warned in the past the hole doesn't match up with the peddle
thinking about just welfing a bracket on, this should work. or does anyone have any better ideas?
pics
http://i102.photobucket.com/albums/m109 ... lebox1.jpg
http://i102.photobucket.com/albums/m109 ... lebox2.jpg
http://i102.photobucket.com/albums/m109 ... lebox3.jpg
http://i102.photobucket.com/albums/m109 ... lebox4.jpg
http://i102.photobucket.com/albums/m109 ... lebox5.jpg
http://i102.photobucket.com/albums/m109 ... lebox6.jpg

[l1ttle_d3vil]

yeah just weld a lug on the side of the pedal which you can attach the push rod to. only needs to be about 1" - 2" long.

I used a piece of round steel about 1.5" long, welded it on the side of the pedal, then welded a small flat plate to the end of that and drilled a hole in it for the push rod. can draw a pic if that doesn't make sense

[79rolla]

all good its sused. drilled a hole in it and put a bolt through. means if it bends i can just chuck another bolt in it

[crispy'86]

I just made a kind of n shaped bracket to go from the te71 clutch pedal i used in my ke35 to the te71 clutch master. Workd well

[79rolla]

here is what i did for future reference

should be the same for ke30 ke36 and maby even ke70?
http://i102.photobucket.com/albums/m109 ... lebox7.jpg
http://i102.photobucket.com/albums/m109 ... lebox8.jpg

sorry bout picture quality. had to take them with web cam as i don't have access to our camera atm