Toyspeed.org.nz Message Board

by **gleem** » Fri Jul 24, 2009 1:30 pm

Unfortanatly when trying to remove the pulley of my sc12 the thread snapped with the nut on the bolt that hols the pulley there. theres a bit of thread left. Im not sdure how these work. Is there a bolt behing that i can repace or what? Or any other ways i can fix this

Thanks

by **Crampy** » Fri Jul 24, 2009 4:36 pm

What? How did you snap that?
It wont be a bolt, it'll be a shaft that goes right through the lower impellor of the charger itself. It'll have a gear on it too, to drive the top impellor.

by **evil_si** » Fri Jul 24, 2009 6:26 pm

wow havent heard of that before,
if its the main bolt in the middle the s/c will have to be replaced.

by **gleem** » Fri Jul 24, 2009 8:22 pm

yeah the main one in the middle of the pulley, i suppose ill just sell as is

by **85AW20v** » Fri Jul 24, 2009 9:09 pm

Anyone know if it's a left or right hand thread - just for future reference.....

by **Crampy** » Sat Jul 25, 2009 5:35 pm

Simon85MR220v wrote:Anyone know if it's a left or right hand thread - just for future reference.....

Probably the opposite way to what this guy did it :lol:

But seriously, dude that sucks really. Bad way to write off a supercharger.

by **tsoob** » Sat Jul 25, 2009 7:58 pm

got a photo ?

Website · by **Rick** » Sun Jul 26, 2009 10:39 am

Its just a normal right handed thread.

Are you talking about the thread/nut in the below picture?

by **gleem** » Sun Jul 26, 2009 7:26 pm

yes but thats the one.

by **JasonZE** » Sun Jul 26, 2009 10:00 pm

just drill the centre out and tap it to fit an 8mm cap screw :lol:

Toyspeed.org.nz Message Board

Supercharger Repair

Supercharger Repair

s/c

Who is online