Toyspeed.org.nz Message Board

by **DXROLLA** » Tue Sep 08, 2009 10:44 pm

Hey i have a bov lying around its just a cheapo and was wondering how to install it, the thing im confused about is that where it goes onto the factory hose it has these 4 screws that you screw in and than nuts you tighten up, but i thought that it would just fly off under pressure or leak as i cant see how it would seal? Or am i missing some part of the assembaly.

Its getting installed onto a 'cough' GTX 'cough' if that matters?

by **no_8wire** » Tue Sep 08, 2009 11:28 pm

Pics may help your case.... :wink:

by **DXROLLA** » Wed Sep 09, 2009 10:51 am

by **tsoob** » Wed Sep 09, 2009 11:09 am

you are missing a piece of the bov. it screws into the bottom of it, is it a GFB valve?

by **DXROLLA** » Wed Sep 09, 2009 11:11 am

No just a cheap one i got a couple of years ago, xspower or something? Is it possible to buy the part im needing or maybe get it made?

by **Paulio** » Wed Sep 09, 2009 11:37 am

Its suppose to mount to a perfect fitting pipe off your intake piping, it wont leak or pop off.

Is the one on the car mounted to a plastic pipe?

You should be able to use an adaptor, sounds like thats what tsoob is talking about.

by **tsoob** » Wed Sep 09, 2009 4:17 pm

yep thats what i was on about, you could use a piece of alloy pipe thats the same size

Toyspeed.org.nz Message Board

Installing BOV

Installing BOV

Who is online