Toyspeed.org.nz Message Board

by **ihavelift** » Mon Feb 01, 2010 4:48 pm

Anybody in Auckland have 1 of these and know how to use it?

I need to check the codes for my engine light which randomly comes on for no reason. No probs with the car at all which is confusing, but I don't want something to go bang while I'm driving around!

Cheers

no grip · by **Akane** » Mon Feb 01, 2010 4:56 pm

Yeah.

The PFC don't have codes as such, if you get the lights flashing while driving it's most likely to be knock warning, pimvolt warning or injector cycle warning, all of 3 which you can monitor with the hand controller.

by **ihavelift** » Mon Feb 01, 2010 5:50 pm

no idea what you just said, any chance we could meet up and sort it out?

no grip · by **Akane** » Mon Feb 01, 2010 7:00 pm

My mum said don't meet up with strangers!

put your PFC hand controller on monitor mode

Monitor these values: (I don't care if you have it on 4 channel or 8 )
PIMVOLT
INJ DUTY
KNOCK

go to the screen where you're monitoring number values
push up, this will only show peak hold values

go for a drive until the said light goes blinking

Note down the values of those items.

Report back.

by **Anth_555** » Mon Feb 01, 2010 9:00 pm

oh my bad you did lol sorry

by **Boosted_162** » Mon Feb 01, 2010 10:11 pm

If you dont have a hand controller and a SW20 3SGTE one will work (not 100% sure it will, same motor tho), i can help.

by **ihavelift** » Tue Feb 02, 2010 5:07 pm

Boosted_162 wrote:If you dont have a hand controller and a SW20 3SGTE one will work (not 100% sure it will, same motor tho), i can help.

that would be good!

no grip · by **Akane** » Tue Feb 02, 2010 10:09 pm

Oh, you don't have a hand controller.

My bad... LOL!

by **Anth_555** » Tue Feb 02, 2010 10:37 pm

i have a celica one but im abit away mr2 should be the same. the apexi still gives you the stock toyota codes so just diagnose it like its a stock ecu

Toyspeed.org.nz Message Board

Apexi PowerFC hand controller

Apexi PowerFC hand controller

Who is online