Toyspeed.org.nz Message Board

Toyota Club of New Zealand Message Board

Skip to content

3RZ-FE factory rev cut (2.7L hilux motor)

The place for all technical car discussions. If you haven't already, read our Disclaimer first!

Moderator: The Mod Squad

Post a reply

3RZ-FE factory rev cut (2.7L hilux motor)

Postby KinLoud » Sun Apr 18, 2010 10:52 pm

Any one know (or can test for me) the factory rev cut for a 3rz-fe motor found in hilux, some hiaces also?
I've done a google search but haven't found anything useful yet

Thanks

Ken
Auck
021 408 863
I used to think that the orange and green tictacs gave you special powers. The orange ones would make you stronger and the green ones would make you faster. So i used to eat some green ones and run around my lounge as fast as i could, then eat the orange ones and try to pick up the sofa. I wish it were true!
User avatar
KinLoud
** Moderator **
 
Posts: 2893
Joined: Thu May 16, 2002 7:39 pm
Location: Auckland
Top

Postby strx7 » Mon Apr 19, 2010 8:36 am

from what i can see on a RZN185 surf dash the redline starts at 5500 and goes to 7000, would assume rev cut is therefore in the 6500 reigon
Online Car Forums - Where Hui seems to take preference over Do-ey

HDJ81- 112AWKW @ 10psi), FC3S (Tarmac Spec 335rwhp@11psi), 3SGTE stroker - replacement body found.

Motorsport Bay of Plenty - http://www.mbop.org.nz
strx7
Toyspeed Member
 
Posts: 3707
Joined: Mon May 24, 2004 12:06 am
Location: Tauranga
Top

Postby KinLoud » Mon Apr 19, 2010 8:54 pm

Thanks for that...
maybe I need to take one for a test drive?
Ha

Ken
I used to think that the orange and green tictacs gave you special powers. The orange ones would make you stronger and the green ones would make you faster. So i used to eat some green ones and run around my lounge as fast as i could, then eat the orange ones and try to pick up the sofa. I wish it were true!
User avatar
KinLoud
** Moderator **
 
Posts: 2893
Joined: Thu May 16, 2002 7:39 pm
Location: Auckland
Top

Postby unstable » Mon Apr 26, 2010 8:49 pm

5800rpm. and do not rev past 6k, the balance shafts will try and escape from the block.
2000 JZX100 Chaser
13.827@167kph@ Nightspeed.
Owner- Pit Stop Grey Lynn. PM for Quotes.
unstable
Toyspeed Member
 
Posts: 19
Joined: Sat Feb 24, 2007 2:31 pm
Top

Postby strx7 » Mon Apr 26, 2010 10:30 pm

unstable wrote:5800rpm. and do not rev past 6k, the balance shafts will try and escape from the block.


might as well buy an old dinosaur ages pushrod V8......
Online Car Forums - Where Hui seems to take preference over Do-ey

HDJ81- 112AWKW @ 10psi), FC3S (Tarmac Spec 335rwhp@11psi), 3SGTE stroker - replacement body found.

Motorsport Bay of Plenty - http://www.mbop.org.nz
strx7
Toyspeed Member
 
Posts: 3707
Joined: Mon May 24, 2004 12:06 am
Location: Tauranga
Top

Postby unstable » Tue Apr 27, 2010 9:56 pm

My last one still made 240rwkw only reving it to 5800rpm. but yes more RPMs would be great.
2000 JZX100 Chaser
13.827@167kph@ Nightspeed.
Owner- Pit Stop Grey Lynn. PM for Quotes.
unstable
Toyspeed Member
 
Posts: 19
Joined: Sat Feb 24, 2007 2:31 pm
Top
Post a reply

Return to Tech Questions

Who is online

Users browsing this forum: No registered users and 12 guests

Powered by phpBB® Forum Software © phpBB Group
Time : 0.016s | 11 Queries | GZIP : On